Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits
Home >>> ISSI >>> IS25LQ016 Datasheet

IS25LQ016 Datasheet

Part NameDescriptionManufacturer
IS25LQ016 8Mbit Single Operating Voltage Serial Flash Memory ISSI
Integrated Silicon Solution ISSI
Other PDF  not available.
PDF DOWNLOAD     
IS25LQ016 image

GENERAL DESCRIPTION
The IS25LQ016 are 16 Mbit Serial Peripheral Interface (SPI) Flash memories, providing single-, dual or quad output. The devices are designed to support a 50 MHz fclock rate in normal read mode, and 104 MHz in fast read (Quad output is 100MHz), the fastest in the industry. The devices use a single low voltage power supply, ranging from 2.3 Volt to 3.6 Volt, to perform read, erase and program operations. The devices can be programmed in standard EPROM programmers.

FEATURES
• Single Power Supply Operation
    - Low voltage range: 2.3 V - 3.6 V
• Memory Organization
    - IS25LQ016: 2048K x 8 (16 Mbit)
• Cost Effective Sector/Block Architecture
    - 16Mb : Uniform 4KByte sectors / Thirty-two uniform 64KByte blocks
• Serial Peripheral Interface (SPI) Compatible
    - Supports single-, dual- or quad-output
    - Supports SPI Modes 0 and 3
    - Maximum 50 MHz clock rate for normal read
    - Maximum 104 MHz clock rate for fast read
    - Maximum 208MHz clock rate equivalent Dual SPI
    - Maximum 400MHz clock rate equivalent Quad SPI
• Byte Program Operation
    - Typical 10 us/Byte
• Page Program (up to 256 Bytes) Operation
    - Maximum 0.7ms per page program
• Sector, Block or Chip Erase Operation
    - Sector Erase (4KB) -> 150ms (Typ)
    - Block Erase (64KB) -> 500ms (Typ)
    - Chip Erase -> 5s (Typ)
• Low Power Consumption
    - Max 12 mA active read current
    - Max 20 mA program/erase current
    - Max 30 uA standby current
• Hardware Write Protection
    - Protect and unprotect the device from write operation by Write Protect (WP#) Pin
• Software Write Protection
    - The Block Protect (BP3, BP2, BP1, BP0) bits allow partial or entire memory to be configured as read-only
• High Product Endurance
    - Guaranteed 100,000 program/erase cycles per single sector
    - Minimum 20 years data retention
• Industrial Standard Pin-out and Package
    - 8-pin 208mil SOIC
    - 8-contact WSON
    - PDIP
    - 8-pin 208mil VSOP
    - Lead-free (Pb-free) package
• Additional 256-byte Security information one-time programmable (OTP) area
• Special protect function
    - Safe guard function (Appendix 1)
    - Sector unlock function (Appendix 2)

 

Other manufacturer searches related to IS25LQ016

Part NameDescriptionPDFManufacturer
PM25LD010 512Kbit/1 Mbit / 2 Mbit Single Operating Voltage Serial Flash Memory With 100 MHz Dual-Output SPI Bus View Unspecified
M25P05-VMN6T 512 Kbit, Low Voltage, Serial Flash Memory With 20 MHz SPI Bus Interface View STMicroelectronics
29W040 4 Mbit 512Kb x8 / Uniform Block Low Voltage Single Supply Flash Memory View STMicroelectronics
MX29F8100 8M-BIT [1M x 8/512K x 16] CMOS SINGLE VOLTAGE FLASH MEMORY View Macronix International
ST7-STICK45 8-bit microcontroller with single voltage Flash memory, data EEPROM, ADC, timers, SPI View STMicroelectronics
F25L016A 16Mbit (2Mx8) 3V Only Serial Flash Memory View [Elite Semiconductor Memory Technology Inc.
LH28F004SU 4Mbit(512Kbit x 8, 256 Kbit x 16) 5V Single Voltage Flash Memory View Sharp Electronics
ST7FDALI 8-BIT MCU WITH SINGLE VOLTAGE FLASH MEMORY, DATA EEPROM, ADC, TIMERS, SPI, DALI View STMicroelectronics
M25P10 1 Mbit Low Voltage Paged Flash Memory With 20 MHz Serial SPI Bus Interface View STMicroelectronics
M29W400B NND - 4 MBIT (512KB X8 OR 256KB X16, BOOT BLOCK) LOW VOLTAGE SINGLE SUPPLY FLASH MEMORY View STMicroelectronics

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]