Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits
Home >>> Winbond >>> W39V040FAQ Datasheet

W39V040FAQ Datasheet

Part NameDescriptionManufacturer
W39V040FAQ 512K × 8 CMOS FLASH MEMORY WITH FWH INTERFACE Winbond
Winbond Winbond
Other PDF  not available.
PDF DOWNLOAD     
W39V040FAQ image

GENERAL DESCRIPTION
The W39V040FA is a 4-megabit, 3.3-volt only CMOS flash memory organized as 512K × 8 bits. For flexible erase capability, the 4Mbits of data are divided into 8 uniform sectors of 64 Kbytes, which are composed of 16 smaller even pages with 4 Kbytes. The device can be programmed and erased in system with a standard 3.3V power supply. A 12-volt VPP is not required. The unique cell architecture of the W39V040FA results in fast program/erase operations with extremely low current consumption.
This device can operate at two modes, Programmer bus interface mode and FWH bus interface mode. As in the Programmer interface mode, it acts like the traditional flash but with a multiplexed address inputs. But in the FWH interface mode, this device complies with the Intel FWH specification. The device can also be programmed and erased using standard EPROM programmers.

FEATURES
• Single 3.3-volt operations:
− 3.3-volt read
− 3.3-volt erase
− 3.3-volt program
• Fast Program operation:
− Byte-by-Byte programming: 35 µS (typ.)
• Fast erase operation:
− Chip erase 100 mS (max.)
− Sector erase 25 mS (max.)
− Page erase 25 mS (max.)
• Fast Read access time: Tkq 11 nS
• Endurance: 10K cycles (typ.)
• Twenty-year data retention
• 8 Even sectors with 64K bytes each, which is composed of 16 flexible pages with 4K bytes
• Any individual sector or page can be erased
• Hardware protection:
− Optional 16K byte or 64K byte Top Boot Block with lockout protection
− #TBL & #WP support the whole chip hardware protection
• Flexible 4K-page size can be used as Parameter Blocks
• Low power consumption
− Active current: 12.5 mA (typ. for FWH mode)
• Automatic program and erase timing with internal VPP generation
• End of program or erase detection
− Toggle bit
− Data polling
• Latched address and data
• TTL compatible I/O
• Available packages: 32L PLCC, 32L STSOP, 40L TSOP (10 x 20 mm)

Page Links : 1  2  3  4  5  6  7  8  9  10  11  12  13  14  15  16  17  18  19  20  21  22  23  24  25  26  27  28  29  30  31  32  33  34  35  36 
 

Other manufacturer searches related to W39V040FAQ

Part NameDescriptionPDFManufacturer
FWH-1000A High Speed Fuses View Cooper Bussmann, Inc.
FWH-.250A6F 6x32mm high speed ferrule fuses View Unspecified
FWH-250A6F 6x32mm high speed ferrule fuses View Unspecified
FWH-.250A6F 1/4" x 1-1/4" Semiconductor Fuses View Cooper Bussmann, Inc.
EN29LV800 8 Megabit (1024K x 8-bit / 512K x 16-bit) Flash Memory Boot Sector Flash Memory, CMOS 3.0 Volt-only View Eon Silicon Solution Inc.
AT29LV040A-20TC 4 Megabit (512K x 8) 3-volt Only 256 Byte Sector CMOS Flash Memory View Atmel Corporation
LH28F800SG 8M (512K × 16) SmartVoltage Flash Memory View Sharp Electronics
LH28F400SUB-Z0 4M (512K × 8, 256K × 16) Flash Memory View Sharp Electronics
LH28F004SU-NC 4M (512K × 8) Flash Memory View Sharp Electronics
S25FL128K 128-Mbit CMOS 3.0 Volt Flash Memory with 104-MHz SPI (Serial Peripheral Interface) Multi I/O Bus View Spansion Inc.

Share Link : 
All Rights Reserved© datasheetq.com 2015 - 2020  ] [ Privacy Policy ] [ Request Datasheet  ] [ Contact Us ]