Electronic component search and free download site.
Transistors,MosFET ,Diode,Integrated circuits

P/N + Description + Content Search

Search Word's :

Part Name(s) : TSSOP-14PIN IR
International Rectifier
Description : TSSOP Package 14-Pin View

(F) TSSOP Package 14-Pin

Part Name(s) : TSSOP-8PIN IR
International Rectifier
Description : (F) TSSOP Package 8-Pin View

(F) TSSOP Package 8-Pin

Part Name(s) : C8051F006 C8051F006-GQ Silabs
Silicon Laboratories
Description : 25 MIPS, 32 kB Flash, 12-Bit ADC, 48-Pin Mixed-Signal MCU View

25 MIPS, 32 kB Flash, 12-Bit ADC, 48-Pin Mixed-Signal MCU


Part Name(s) : RD74LVC16240B RD74LVC16240BTEL Renesas
Renesas Electronics
Description : 16-bit Buffers / Line Drivers with 3-state Outputs / TSSOP48 Pin View

The RD74LVC16240B has sixteen inverter drivers with three state outputs in a 48 Pin package. This device is a inverting buffer and has two active low enables (1Gto 4G). Each enable independently controls four buffers. Low voltage and high-speed operation is suitable at the battery drive product (note type personal computer) and low power consumption extends the life of a battery for long time operation.





Part Name(s) : CY7C68023-56LTXC CY7C68023_11 CY7C68024_11 Cypress
Cypress Semiconductor
Description : EZ-USB NX2LP™ USB 2.0 NAND Flash Controller View

Introduction
The EZ-USB NX2LP™ (NX2LP) implements a USB 2.0 NAND Flash controller. This controller adheres to the Mass Storage Class Bulk-Only Transport Specification. The USB port of the NX2LP is connected to a host computer directly or through the downstream port of a USB hub. Host software issues commands and data to the NX2LP and receives status and data from the NX2LP using standard USB protocol.
The NX2LP supports industry leading 8-bit NAND Flash interfaces and both common NAND page sizes of 512 and 2k bytes. Eight chip enable Pins allow the NX2LP to be connected to up to eight single or four dual device NAND Flash chips.
Certain NX2LP features are configurable, enabling the NX2LP to meet the needs of different design requirements.

Features
■ High (480-Mbps) or Full (12-Mbps) Speed USB Support
■ Both Common NAND Page Sizes Supported
   ❐ 512 bytes — Up to 1 Gbit Capacity
   ❐ 2K bytes — Up to 8 Gbit Capacity
■ Eight Chip Enable Pins
   ❐ Up to 8 NAND Flash Single Device Chips
   ❐ Up to 4 NAND Flash Dual Device Chips
■ Industry Standard ECC NAND Flash Correction
   ❐ 1 bit per 256 correction
   ❐ 2 bit error detection
■ Industry Standard (SmartMedia) Page Management for Wear
   Leveling Algorithm, Bad Block Handling, and Physical to
   Logical management
■ Supports 8-bit NAND Flash Interfaces
■ Supports 30 ns, 50 ns, and 100 ns NAND Flash Timing
■ Complies with USB Mass Storage Class Specification rev 1.0
■ CY7C68024 Complies with USB 2.0 Specification for
   Bus-Powered Devices (TID# 40460274)
■ 43 mA Typical Active Current
■ Space Saving and Pb-free 56-QFN Package (8 mm × 8 mm)
■ Support for Board-level Manufacturing test through USB Interface
■ 3.3 V NAND Flash Operation
NAND Flash Power Management Support

Part Name(s) : TC5816BDC Toshiba
Toshiba
Description : 16 MBIT (2M x 8 BITS) CMOS NAND Flash E2PROM View

16 MBIT (2M x 8 BITS) CMOS NAND Flash E2PROM

Part Name(s) : C8051F236 ETC
Unspecified
Description : 8K Flash, 1.25K RAM, 48-Pin MCU View

[CYGNAL]

ANALOG PERIPHERALS

Two Comparators
- Programmable Hysteresis
- Configurable to Generate Interrupts or Reset

VDD Monitor and Brown-out Detector

ON-CHIP JTAG DEBUG
- On-Chip Debug Circuitry Facilitates Full Speed, Non-Intrusive In-System Debug (No Emulator Required!)
- Provides Breakpoints, Single StepPing, Watchpoints, Stack Monitor
- Inspect/Modify Memory and Registers
- Superior Performance to Emulation Systems Using ICE-Chips, Target Pods, and Sockets
- Low Cost, Complete Development Kit

SUPPLY VOLTAGE ......................2.7V to 3.6V
- Typical Operating Current: 9mA @ 25MHz
- Typical Stop Mode Current: <0.1uA

Temperature Range: –40°C to +85°C
48-Pin TQFP Package

8051-COMPATIBLE µC Core
- Pipelined Instruction Architecture; Executes 70% of Instructions in 1 or 2 System Clocks
- Up to 25MIPS Throughput with 25MHz Clock
- Expanded Interrupt Handler

MEMORY
- 1280 Bytes Internal Data RAM (256 + 1k)
- 8k Bytes Flash; In-System Programmable in 512 byte Sectors

DIGITAL PERIPHERALS
- 32 Port I/O; All are 5V tolerant
- Hardware SPITM and UART Serial Ports Available Concurrently
- Three 16-bit Counter/Timers
- Dedicated Watch-Dog Timer
- Bi-directional Reset

CLOCK SOURCES
- Internal Programmable Oscillator: 2-to-16MHz
- External Oscillator: Crystal, RC, C, or Clock
- Can Switch Between Clock Sources on-the-fly; Useful in Power Saving Modes

Part Name(s) : C8051F23 C8051F230 ETC
Unspecified
Description : 8K Flash, 256 RAM, 48-Pin MCU View

[CYGNAL]

ANALOG PERIPHERALS

Two Comparators
- Programmable Hysteresis
- Configurable to Generate Interrupts or Reset

VDD Monitor and Brown-out Detector

ON-CHIP JTAG DEBUG
- On-Chip Debug Circuitry Facilitates Full Speed, Non-Intrusive In-System Debug (No Emulator Required!)
- Provides Breakpoints, Single StepPing, Watchpoints, Stack Monitor
- Inspect/Modify Memory and Registers
- Superior Performance to Emulation Systems Using ICE-Chips, Target Pods, and Sockets
- Low Cost, Complete Development Kit

SUPPLY VOLTAGE ......................2.7V to 3.6V
- Typical Operating Current: 9mA @ 25MHz
- Typical Stop Mode Current: <0.1uA

Temperature Range: –40°C to +85°C
48-Pin TQFP Package

8051-COMPATIBLE µC Core
- Pipelined Instruction Architecture; Executes 70% of Instructions in 1 or 2 System Clocks
- Up to 25MIPS Throughput with 25MHz Clock
- Expanded Interrupt Handler

MEMORY
- 256 Bytes Data RAM
- 8k Bytes Flash; In-System Programmable in 512 byte Sectors

DIGITAL PERIPHERALS
- 32 Port I/O (All 5V tolerant with High Sink Current)
- Hardware SPITM and UART Serial Ports Available Concurrently
- Three General Purpose 16-bit Counter/Timers
- Dedicated Watch-Dog Timer; Bi-directional Reset

CLOCK SOURCES
- Internal Programmable Oscillator (2 to 16MHz)
- External Oscillator: Crystal, RC, C, or Clock
- Can Switch Between Clock Sources on-the-fly; Useful in Power Saving Modes

Part Name(s) : CY7C68023 CY7C68024 CY7C68023-56LFXC CY7C68024-56LFXC CY3685 CY4618 Cypress
Cypress Semiconductor
Description : EZ-USB NX2LP™ USB 2.0 NAND Flash Controller View

Introduction
The EZ-USB NX2LP™ (NX2LP) implements a USB 2.0 NAND Flash controller. This controller adheres to the Mass Storage Class Bulk-Only Transport Specification. The USB port of the NX2LP is connected to a host computer directly or via the downstream port of a USB hub. Host software issues commands and data to the NX2LP and receives status and data from the NX2LP using standard USB protocol.
The NX2LP supports industry leading 8-bit NAND Flash interfaces and both common NAND page sizes of 512 and 2k bytes. Eight chip enable Pins allow the NX2LP to be connected to up to eight single- or four dual-device NAND Flash chips.
Certain NX2LP features are configurable, enabling the NX2LP to meet the needs of different designs’ requirements.

Features
• High (480-Mbps) or full (12-Mbps) speed USB support
• Both common NAND page sizes supported
   — 512bytes –Up to 1Gbit Capacity
   — 2K bytes –Up to 8Gbit Capacity
• 8 chip enable Pins
   — Up to 8 NAND Flash single-device chips
   — Up to 4 NAND Flash dual-device chips
• Industry standard ECC NAND Flash correction
   — 1-bit per 256 correction
   — 2-bit error detection
• Industry standard (SmartMedia) page management for
   wear leveling algorithm, bad block handling, and Physical
   to Logical management.
• Supports 8-bit NAND Flash interfaces
• Supports 30ns, 50ns, 100ns NAND Flash timing
• Complies with USB Mass Storage Class Specification rev 1.0
• CY7C68024 complies with USB 2.0 Specification for Bus
   Powered Devices (TID# 40460274)
• 43-mA Typical Active Current
• Space-saving and lead-free 56-QFN package (8mm × 8mm)
• Support for board-level manufacturing test via USB interface
• 3.3V NAND Flash operation
NAND Flash power management support

12345678910 Next



All Rights Reserved© datasheetq.com 2015 - 2019  [ Privacy Policy ] [ Request Datasheet ] [ Contact Us ]