â GENERAL DESCRIPTION
The MBM29LV160TE/BE is a 16M-bit, 3.0 V-only Flash memory organized as 2M bytes of 8 bits each or 1M words of 16 bits each. The MBM29LV160TE/BE is offered in a 48-pin TSOP (I), 48-pin CSOP and 48-ball FBGA packages. The device is designed to be programmed in-system with the standard system 3.0 V VCC supply. 12.0 V VPP and 5.0 V VCC are not required for write or erase operations. The device can also be reprogrammed in standard EPROM programmers.
â FEATURES
⢠0.23 µm Process Technology
⢠Single 3.0 V read, program and erase
  Minimizes system level power requirements
⢠Compatible with JEDEC-standard commands
  Uses same software commands as E2PROMs
⢠Compatible with JEDEC-standard world-wide pinouts
  48-pin TSOP (I) (Package suffix: TN-Normal Bend Type, TR-Reversed Bend Type)
  48-pin CSOP (Package suffix: PCV)
  48-ball FBGA (Package suffix: PBT)
⢠Minimum 100,000 program/erase cycles
⢠High performance
  70 ns maximum access time
⢠Sector erase architecture
  One 8K word, two 4K words, one 16K word, and thirty-one 32K words sectors in word mode
  One 16K byte, two 8K bytes, one 32K byte, and thirty-one 64K bytes sectors in byte mode
  Any combination of sectors can be concurrently erased. Also supports full chip erase
⢠Boot Code Sector Architecture
  T = Top sector
  B = Bottom sector
⢠Embedded EraseTM Algorithms
  Automatically pre-programs and erases the chip or any sector
⢠Embedded ProgramTM Algorithms
  Automatically programs and verifies data at specified address
⢠Data Polling and Toggle Bit feature for detection of program or erase cycle completion
⢠Ready/Busy output (RY/BY)
  Hardware method for detection of program or erase cycle completion
⢠Automatic sleep mode
  When addresses remain stable, automatically switches themselves to low power mode
⢠Low VCC write inhibit ⤠2.5 V
⢠Erase Suspend/Resume
  Suspends the erase operation to allow a read data and/or program in another sector within the same device
⢠Sector protection
  Hardware method disables any combination of sectors from program or erase operations
⢠Sector Protection Set function by Extended sector Protection command
⢠Fast Programming Function by Extended command
⢠Temporary sector unprotection
  Temporary sector unprotection via the RESET pin
⢠In accordance with CFI (Common Flash Memory Interface)
Â
|