ATMEGA64L-8MI View Datasheet(PDF) - Atmel Corporation

Part Name

Description

Manufacturer

ATMEGA64L-8MI

8-bit AVR® Microcontroller with 64K Bytes In-System Programmable Flash

Atmel Corporation 

JTAG Interface and

On-chip Debug System

If the On-chip debug system is enabled by the OCDEN Fuse and the chip enter Power

down or Power save sleep mode, the main clock source remains enabled. In these

sleep modes, this will contribute significantly to the total current consumption. There are

three alternative ways to avoid this:

• Disable OCDEN Fuse.

• Disable JTAGEN Fuse.

• Write one to the JTD bit in MCUCSR.

The TDO pin is left floating when the JTAG interface is enabled while the JTAG TAP

controller is not shifting data. If the hardware connected to the TDO pin does not pull up

the logic level, power consumption will increase. Note that the TDI pin for the next

device in the scan chain contains a pull-up that avoids this problem. Writing the JTD bit

in the MCUCSR register to one or leaving the JTAG fuse unprogrammed disables the

JTAG interface.

48 ATmega64(L)

2490G–AVR–03/04

Share Link: