C8051F045 View Datasheet(PDF) - Silicon Laboratories

Part Name

Description

Manufacturer

C8051F045

Mixed Signal ISP Flash MCU Family

Silicon Laboratories 

C8051F040/1/2/3/4/5/6/7

14.4. External Crystal Example

If a crystal or ceramic resonator is used as an external oscillator source for the MCU, the circuit should be

configured as shown in Figure 14.1, Option 1. The External Oscillator Frequency Control value (XFCN)

should be chosen from the Crystal column of the table in SFR Definition 14.4 (OSCXCN register). For

example, an 11.0592 MHz crystal requires an XFCN setting of 111b.

When the crystal oscillator is enabled, the oscillator amplitude detection circuit requires a settle time to

achieve proper bias. Introducing a delay of at least 1 ms between enabling the oscillator and checking the

XTLVLD bit will prevent a premature switch to the external oscillator as the system clock. Switching to the

external oscillator before the crystal oscillator has stabilized can result in unpredictable behavior. The rec-

ommended procedure is:

Step 1. Enable the external oscillator in crystal oscillator mode.

Step 2. Wait at least 1 ms.

Step 3. Poll for XTLVLD => '1'.

Step 4. Switch the system clock to the external oscillator.

Note: Tuning-fork crystals may require additional settling time before XTLVLD returns a valid result.

The capacitors shown in the external crystal configuration provide the load capacitance required by the

crystal for correct oscillation. These capacitors are "in series" as seen by the crystal and "in parallel" with

the stray capacitance of the XTAL1 and XTAL2 pins.

Note: The load capacitance depends upon the crystal and the manufacturer. Please refer to the crystal

data sheet when completing these calculations.

For example, a tuning-fork crystal of 32.768 kHz with a recommended load capacitance of 12.5 pF should

use the configuration shown in Figure 14.1, Option 1. The total value of the capacitors and the stray capac-

itance of the XTAL pins should equal 25 pF. With a stray capacitance of 3 pF per pin, the 22 pF capacitors

yield an equivalent capacitance of 12.5 pF across the crystal, as shown in Figure 14.2.

22 pF

XTAL1

32.768 kHz

10 M

22 pF

XTAL2

Figure 14.2. 32.768 kHz External Crystal Example

Important Note on External Crystals: Crystal oscillator circuits are quite sensitive to PCB layout. The

crystal should be placed as close as possible to the XTAL pins on the device. The traces should be as

short as possible and shielded with ground plane from any other traces which could introduce noise or

interference.

Rev. 1.5

177

Share Link: