ST7PLITE39F2U6TR View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST7PLITE39F2U6TR

8-bit MCU with single voltage Flash, data EEPROM, ADC, timers, SPI, LINSCI™

STMicroelectronics 

ST7LITE3xF2

If both the RC oscillator and the PLL are disabled,

fOSC is driven by the external clock.

Figure 12. PLL Output Frequency Timing

Diagram

LOCKED bit set

4/8 x

input

freq.

tSTAB

tLOCK

tSTARTUP

t

When the PLL is started, after reset or wakeup

from Halt mode or AWUFH mode, it outputs the

clock after a delay of tSTARTUP.

When the PLL output signal reaches the operating

frequency, the LOCKED bit in the SICSCR register

is set. Full PLL accuracy (ACCPLL) is reached after

a stabilization time of tSTAB (see Figure 12 and

13.3.4Internal RC Oscillator and PLL)

Refer to section 7.6.4 on page 34 for a description

of the LOCKED bit in the SICSR register.

7.3 REGISTER DESCRIPTION

MAIN CLOCK CONTROL/STATUS REGISTER

(MCCSR)

Read / Write

Reset Value: 0000 0000 (00h)

7

0

0

0

0

0

0

0 MCO SMS

Bits 7:2 = Reserved, must be kept cleared.

Bit 1 = MCO Main Clock Out enable

This bit is read/write by software and cleared by

hardware after a reset. This bit allows to enable

the MCO output clock.

0: MCO clock disabled, I/O port free for general

purpose I/O.

1: MCO clock enabled.

Bit 0 = SMS Slow Mode select

This bit is read/write by software and cleared by

hardware after a reset. This bit selects the input

clock fOSC or fOSC/32.

0: Normal mode (fCPU = fOSC

1: Slow mode (fCPU = fOSC/32)

RC CONTROL REGISTER (RCCR)

Read / Write

Reset Value: 1111 1111 (FFh)

7

0

CR9 CR8 CR7 CR6 CR5 CR4 CR3 CR2

Bits 7:0 = CR[9:2] RC Oscillator Frequency Ad-

justment Bits

These bits must be written immediately after reset

to adjust the RC oscillator frequency and to obtain

an accuracy of 1%. The application can store the

correct value for each voltage range in EEPROM

and write it to this register at start-up.

00h = maximum available frequency

FFh = lowest available frequency

These bits are used with the CR[1:0] bits in the

SICSR register. Refer to section 7.6.4 on page 34

Note: To tune the oscillator, write a series of differ-

ent values in the register until the correct frequen-

cy is reached. The fastest method is to use a di-

chotomy starting with 80h.

24/173

1

Share Link: