PIC18F65K80T-I/SS View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC18F65K80T-I/SS

28/40/44/64-Pin, Enhanced Flash Microcontrollers with ECAN™ and nanoWatt XLP Technology

Microchip Technology 

PIC18F66K80 FAMILY

TABLE 31-1: MEMORY PROGRAMMING REQUIREMENTS

DC CHARACTERISTICS

Standard Operating Conditions

Operating temperature -40°C  TA  +85°C for Industrial

-40°C  TA  +125°C for Extended

Param

No.

Sym

Characteristic

Min

Typ† Max Units

Conditions

Internal Program Memory

Programming Specifications(1)

D110 VPP Voltage on MCLR/VPP/RE5 pin VDD + 1.5 —

D113 IDDP Supply Current during

Programming

—

—

10

V (Note 3, Note 4)

10 mA

D120

D121

ED

VDRW

Data EEPROM Memory

Byte Endurance

VDD for Read/Write

D122 TDEW Erase/Write Cycle Time

D123 TRETD Characteristic Retention

D124 TREF Number of Total Erase/Write

Cycles before Refresh(2)

(Note 2)

100K 1000K — E/W -40C to +125C

1.8

—

5.5

V Using EECON to read/write

PIC18FXXKXX devices

1.8

—

3.6

V Using EECON to read/write

PIC18LFXXKXX devices

—

4

—

ms

20

—

— Year Provided no other

specifications are violated

1M

10M

— E/W -40°C to +125°C

Program Flash Memory

D130 EP Cell Endurance

1K

10K

— E/W -40C to +125C

D131 VPR VDD for Read

1.8

—

5.5

V PIC18FXXKXX devices

1.8

—

3.6

V PIC18LFXXKXX devices

D132B VPEW Voltage for Self-Timed Erase or

Write Operations

VDD

1.8

—

5.5

V PIC18FXXKXX devices

D133A TIW Self-Timed Write Cycle Time

—

2

—

ms

D134 TRETD Characteristic Retention

20

—

— Year Provided no other

specifications are violated

D135 IDDP Supply Current during

Programming

—

—

10 mA

D140 TWE Writes per Erase Cycle

—

—

1

For each physical address

† Data in “Typ” column is at 3.3V, 25°C unless otherwise stated. These parameters are for design guidance

only and are not tested.

Note 1:

2:

3:

4:

These specifications are for programming the on-chip program memory through the use of table write

instructions.

Refer to Section 8.8 “Using the Data EEPROM” for a more detailed discussion on data EEPROM

endurance.

Required only if Single-Supply Programming is disabled.

The MPLAB® ICD 2 does not support variable VPP output. Circuitry to limit the ICD2 VPP voltage must be

placed between the ICD 2 and target system when programming or debugging with the ICD2.

DS39977F-page 558

 2010-2012 Microchip Technology Inc.

Share Link: