STPCC03 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STPCC03

PC Compatible Embeded Microprocessor

STMicroelectronics 

PIN DESCRIPTION

DACK_ENC[2:0] DMA Acknowledge. These are

the ISA bus DMA acknowledge signals. They are

encoded by the STPC Consumer-S before output

and should be decoded externally using ISACLK

and ISACLKX2 as the control strobes.

TC ISA Terminal Count. This is the terminal count

output of the DMA controller and is connected to

the TC line of the ISA bus. It is asserted during the

last DMA transfer, when the byte count expires.

2.2.6 LOCAL BUS

PA[21:0] Address Bus Output.

PD[15:0] Data Bus. This is the 16-bit data bus.

D[7:0] is the LSB and PD[15:8] is the MSB.

PWR#[1:0] Write Control output. PWR0# is used

to write the LSB and PWR1# to write the MSB.

2.2.5 X-Bus Interface pins

RTCAS# Real time clock address strobe. This sig-

nal is asserted for any I/O write to port 70H.

RMRTCCS# ROM/Real Time clock chip select.

This signal is asserted if a ROM access is decod-

ed during a memory cycle. It should be combined

with MEMR# or MEMW# signals to properly ac-

cess the ROM. During a IO cycle, this signal is as-

serted if access to the Real Time Clock (RTC) is

decoded. It should be combined with IOR or IOW#

signals to properly access the real time clock.

KBCS# Keyboard Chip Select. This signal is as-

serted if a keyboard access is decoded during a I/

O cycle.

RTCRW# Real Time Clock RW. This pin is a multi-

function pin. When ISAOE# is active, this signal is

used as RTCRW#. This signal is asserted for any

I/O write to port 71H.

RTCDS# Real Time Clock DS. This pin is a multi-

function pin. When ISAOE# is active, this signal is

used as RTCDS. This signal is asserted for any I/

O read to port 71H.

Note: RMRTCCS#, KBCS#, RTCRW# and

RTCDS# signals must be ORed externally with

ISAOE# and then connected to the external de-

vice. An LS244 or equivalent function can be used

if OE# is connected to ISAOE# and the output is

provided with a weak pull-up resistor as shown in

Figure 2.2.

PRD#[1:0] Read Control output. PRD0# is used

to read the LSB and PRD1# to read the MSB.

PRDY# Data Ready input. This signal is used to

create wait states on the bus. When low, it com-

pletes the current cycle.

FCS#[1:0] Flash Chip Select output. These are

the Programmable Chip Select signals for up to 2

banks of Flash memory.

IOCS#[3:0] I/O Chip Select output. These are the

Programmable Chip Select signals for up to 4 ex-

ternal I/O devices.

17/51

Release B

This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change without notice.

Share Link: