PIC16LF873T-20ISO View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16LF873T-20ISO

28/40-Pin 8-Bit CMOS FLASH Microcontrollers

Microchip Technology 

PIC16F87X

15.3 DC Characteristics: PIC16F873/874/876/877-04 (Extended)

PIC16F873/874/876/877-10 (Extended) (Continued)

PIC16F873/ 874/ 876/ 877-04

PIC16F873/ 874/ 876/ 877-20

(Extended)

Standard Operating Conditions (unless otherwise stated)

Operating temperature -40°C ≤ TA ≤ +125°C

Param Symbol

No.

Characteristic/

Device

Min Typ† Max Units

Conditions

IDD Supply Current(2,5)

D010

— 1.6 4 mA RC osc configurations

FOSC = 4 MHz, VDD = 5.5V

D013

—

7

15 mA HS osc configuration,

FOSC = 10 MHz, VDD = 5.5V

D015

∆IBOR Brown-out

—

Reset Current(6)

IPD Power-down Current(3,5)

85 200 µA BOR enabled, VDD = 5.0V

D020A

10.5 60 µA VDD = 4.0V, WDT enabled

D021B

1.5 30 µA VDD = 4.0V, WDT disabled

D023

∆IBOR Brown-out

Reset Current(6)

— 85 200 µA BOR enabled, VDD = 5.0V

† Data is “Typ” column is at 5V, 25°C, unless otherwise stated. These parameters are for design guidance

only, and are not tested.

Note 1: This is the limit to which VDD can be lowered without losing RAM data.

2: The supply current is mainly a function of the operating voltage and frequency. Other factors such as I/O pin

loading, switching rate, oscillator type, internal code execution pattern and temperature also have an impact

on the current consumption.

The test conditions for all IDD measurements in active operation mode are:

OSC1 = external square wave, from rail to rail; all I/O pins tri-stated, pulled to VDD;

MCLR = VDD; WDT enabled/disabled as specified.

3: The power-down current in SLEEP mode does not depend on the oscillator type. Power-down current is

measured with the part in SLEEP mode, with all I/O pins in hi-impedance state and tied to VDD and VSS.

4: For RC osc configuration, current through REXT is not included. The current through the resistor can be

estimated by the formula Ir = VDD/2REXT (mA) with REXT in kOhm.

5: Timer1 oscillator (when enabled) adds approximately 20 µA to the specification. This value is from

characterization and is for design guidance only. This is not tested.

6: The ∆ current is the additional current consumed when this peripheral is enabled. This current should be

added to the base IDD or IPD measurement.

7: When BOR is enabled, the device will operate correctly until the VBOR voltage trip point is reached.

DS30292C-page 158

 2001 Microchip Technology Inc.

Share Link: