ST72E121J4D0 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST72E121J4D0

8-BIT MCU WITH 8 TO 16K OTP/EPROM, 384 TO 512 BYTES RAM, WDG, SCI, SPI AND 2 TIMERS

STMicroelectronics 

ST72E121 ST72T121

16-BIT TIMER (Cont’d)

4.3.4 Low Power Modes

Mode

WAIT

HALT

Description

No effect on 16-bit Timer.

Timer interrupts cause the device to exit from WAIT mode.

16-bit Timer registers are frozen.

In HALT mode, the counter stops counting until Halt mode is exited. Counting resumes from the previous

count when the MCU is woken up by an interrupt with “exit from HALT mode” capability or from the counter

reset value when the MCU is woken up by a RESET.

If an input capture event occurs on the ICAPi pin, the input capture detection circuitry is armed. Consequent-

ly, when the MCU is woken up by an interrupt with “exit from HALT mode” capability, the ICFi bit is set, and

the counter value present when exiting from HALT mode is captured into the ICiR register.

4.3.5 Interrupts

Interrupt Event

Input Capture 1 event/Counter reset in PWM mode

Input Capture 2 event

Output Compare 1 event (not available in PWM mode)

Output Compare 2 event (not available in PWM mode)

Timer Overflow event

Event

Flag

ICF1

ICF2

OCF1

OCF2

TOF

Enable

Control

Bit

ICIE

OCIE

TOIE

Exit

from

Wait

Yes

Yes

Yes

Yes

Yes

Exit

from

Halt

No

No

No

No

No

Note: The 16-bit Timer interrupt events are con-

nected to the same interrupt vector (see Interrupts

chapter).

These events generate an interrupt if the corre-

sponding Enable Control Bit is set and the I-bit in

the CC register is reset (RIM instruction).

44/92

44

Share Link: