AD7980BCPZ-RL(RevC) View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

AD7980BCPZ-RL
(Rev.:RevC)

16-Bit, 1 MSPS PulSAR ADC in MSOP/QFN

Analog Devices 

AD7980

CS MODE 4-WIRE WITH BUSY INDICATOR

This mode is usually used when a single AD7980 is connected

to an SPI-compatible digital host that has an interrupt input,

and it is desired to keep CNV, which is used to sample the

analog input, independent of the signal used to select the

data reading. This requirement is particularly important in

applications where low jitter on CNV is desired.

The connection diagram is shown in Figure 37, and the

corresponding timing is given in Figure 38.

With SDI high, a rising edge on CNV initiates a conversion,

selects the CS mode, and forces SDO to high impedance. In this

mode, CNV must be held high during the conversion phase and

the subsequent data readback (if SDI and CNV are low, SDO is

driven low). Prior to the minimum conversion time, SDI can be

used to select other SPI devices, such as analog multiplexers,

but SDI must be returned low before the minimum conversion

time elapses and then held low for the maximum conversion

time to guarantee the generation of the busy signal indicator.

When the conversion is complete, SDO goes from high impedance

to low.

Data Sheet

With a pull-up on the SDO line, this transition can be used as

an interrupt signal to initiate the data readback controlled by

the digital host. The AD7980 then enters the acquisition phase

and powers down. The data bits are clocked out, MSB first, by

subsequent SCK falling edges. The data is valid on both SCK

edges. Although the rising edge can be used to capture the data,

a digital host using the SCK falling edge allows a faster reading

rate provided it has an acceptable hold time. After the optional

17th SCK falling edge or SDI going high, whichever is earlier,

the SDO returns to high impedance.

CS1

CONVERT

CNV

SDI AD7980 SDO

VIO

47kΩ

DIGITAL HOST

DATA IN

SCK

IRQ

CLK

Figure 37. 4-Wire CS Mode with Busy Indicator Connection Diagram

CNV

AQUISITION

tCONV

CONVERSION

tCYC

tACQ

AQUISITION

tSSDICNV

SDI

tHSDICNV

SCK

SDO

tSCKL

tSCK

1

2

3

15

16

17

tHSDO

tSCKH

tDSDO

tDIS

tEN

D15

D14

D1

D0

Figure 38. 4-Wire CS Mode with Busy Indicator Serial Interface Timing

Rev. C | Page 20 of 28

Share Link: