AD8065ART-EBZ View Datasheet(PDF) - Analog Devices

Part Name

Description

Manufacturer

AD8065ART-EBZ

High Performance, 145 MHz FastFET Op Amps

Analog Devices 

AD8065/AD8066

THERMAL CONSIDERATIONS

With 24 V power supplies and 6.5 mA quiescent current, the

AD8065 dissipates 156 mW with no load. The AD8066 dissipates

312 mW. This can lead to noticeable thermal effects, especially

in the small SOT-23-5 (thermal resistance of 160°C/W). VOS

temperature drift is trimmed to guarantee a maximum drift of

17 μV/°C, so it can change up to 0.425 mV due to warm-up

effects for an AD8065/AD8066 in a SOT-23-5 package on 24 V.

Ib increases by a factor of 1.7 for every 10°C rise in temperature.

Ib is close to five times higher at 24 V supplies as opposed to a

single 5 V supply.

Heavy loads increase power dissipation and raise the chip

junction temperature as described in the Maximum Power

Dissipation section. Care should be taken not to exceed the

rated power dissipation of the package.

INPUT AND OUTPUT OVERLOAD BEHAVIOR

A simplified schematic of the AD8065/AD8066 input stage is

shown in Figure 56. This shows the cascoded N-channel JFET

input pair, the ESD and other protection diodes, and the

auxiliary NPN input stage that eliminates any phase inversion

behavior. When the common-mode input voltage to the amplifier

is driven to within approximately 3 V of the positive power supply,

the input JFET’s bias current turns off and the bias of the NPN

pair turns on, taking over control of the amplifier. The NPN

differential pair now sets the amplifier’s offset, and the input

bias current is now in the range of several tens of microamps.

This behavior is shown in Figure 32. Normal operation resumes

when the common-mode voltage goes below the 3 V from the

positive supply threshold.

The output transistors of the rail-to-rail output stage have

circuitry to limit the extent of their saturation when the output

is overdriven. This helps output recovery time. Output recovery

from a 0.5 V output overdrive on a ±5 V supply is shown in

Figure 24.

VTHRESHOLD

R1

Q2

VCC

R5

TO REST OF AMP

Q5

VBIAS

D1

R6

R3

Q1

VN

D3

D2

Q6

D4

VP

Q3

Q4

S

R4

R7

S

R2

R8

Q7

IT1

IT2

–VEE

Figure 56. Simplified Input Stage

Rev. J | Page 22 of 28

Share Link: