C8051F317 View Datasheet(PDF) - Silicon Laboratories
Part Name
Description
Manufacturer
C8051F317 Datasheet PDF : 224 Pages
| |||
C8051F310/1/2/3/4/5/6/7
1.8. Comparators
C8051F31x devices include two on-chip voltage comparators that are enabled/disabled and configured via
user software. Port I/O pins may be configured as comparator inputs via a selection mux. Two comparator
outputs may be routed to a Port pin if desired: a latched output and/or an unlatched (asynchronous) output.
Comparator response time is programmable, allowing the user to select between high-speed and low-
power modes. Positive and negative hysteresis are also configurable.
Comparator interrupts may be generated on rising, falling, or both edges. When in IDLE mode, these inter-
rupts may be used as a “wake-up” source. Comparator0 may also be configured as a reset source.
Figure 1.16 shows he Comparator0 block diagram.
CMX0N1
CMX0N0
CMX0P1
CMX0P0
CP0EN
CP0OUT
CP0RIF
CP0FIF
CP0HYP1
CP0HYP0
CP0HYN1
CP0HYN0
VDD
CP0
Interrupt
P1.0
P1.4
P2.0
P2.4
P1.1
P1.5
P2.1
P2.5
CP0
Rising-edge
CP0
Falling-edge
CP0 +
CP0 -
+
-
GND
SET
DQ
Q
CLR
SET
DQ
Q
CLR
(SYNCHRONIZER)
Reset
Decision
Tree
CP0RIE
CP0FIE
Interrupt
Logic
CP0
Crossbar
CP0A
CP0MD1
CP0MD0
Figure 1.16. Comparator0 Block Diagram
34
Rev. 1.6
Share Link: 