C8051F342 View Datasheet(PDF) - Silicon Laboratories

Part Name

Description

Manufacturer

C8051F342

Full Speed USB Flash MCU Family

Silicon Laboratories 

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D

5.2. Temperature Sensor

The temperature sensor transfer function is shown in Figure 5.2. The output voltage (VTEMP) is the positive

ADC input when the temperature sensor is selected by bits AMX0P4-0 in register AMX0P. Values for the

Offset and Slope parameters can be found in Table 5.1.

VTEMP = (Gain x TempC) + Offset

TempC = (VTEMP - Offset) / Gain

Gain (V / deg C)

Offset (V at 0 Celsius)

Temperature

Figure 5.2. Temperature Sensor Transfer Function

The uncalibrated temperature sensor output is extremely linear and suitable for relative temperature mea-

surements (see Table 5.1 for linearity specifications). For absolute temperature measurements, offset and/

or gain calibration is recommended. Typically a 1-point (offset) calibration includes the following steps:

Step 1. Control/measure the ambient temperature (this temperature must be known).

Step 2. Power the device, and delay for a few seconds to allow for self-heating.

Step 3. Perform an ADC conversion with the temperature sensor selected as the positive input

and GND selected as the negative input.

Step 4. Calculate the offset characteristics, and store this value in non-volatile memory for use

with subsequent temperature sensor measurements.

Figure 5.3 shows the typical temperature sensor error assuming a 1-point calibration at 25 °C. Note that

parameters which affect ADC measurement, in particular the voltage reference value, will also

affect temperature measurement.

Rev. 1.3

43

Share Link: