CS42888-DQZR View Datasheet(PDF) - Cirrus Logic

Part Name

Description

Manufacturer

CS42888-DQZR

108 dB, 192 kHz 4-In, 8-Out CODEC

Cirrus Logic 

7.1.1

CS42888

Passive Input Filter

The passive filter implementation shown in Figure 27 will attenuate any noise energy at 6.144 MHz but

will not provide optimum source impedance for the ADC modulators. Full analog performance will there-

fore not be realized using a passive filter. Figure 27 illustrates the unity gain, passive input filter solution.

In this topology the distortion performance is affected, but the dynamic range performance is not limited.

150 Ω

100 kΩ

10 µF

2700 pF

C0G

ADC1-2

AIN1+,2+,3+,4+

4.7 µF

AIN1-,2-,3-,4-

Figure 27. Passive Input Filter

7.1.2

Passive Input Filter w/Attenuation

Some applications may require signal attenuation prior to the ADC. The full-scale input voltage will scale

with the analog power supply voltage. For VA = 5.0 V, the full-scale input voltage is approximately

2.8 Vpp, or 1 Vrms (most consumer audio line-level outputs range from 1.5 to 2 Vrms).

Figure 28 shows a passive input filter with 6 dB of signal attenuation. Due to the relatively high input im-

pedance on the analog inputs, the full distortion performance cannot be realized. Also, the resistor divider

circuit will determine the input impedance into the input filter. In the circuit shown in Figure 28, the input

impedance is approximately 5 kΩ. By doubling the resistor values, the input impedance will increase to

10 kΩ. However, in this case the distortion performance will drop due to the increase in series resistance

on the analog inputs.

2.5 kΩ

2.5 kΩ

10 µF

2700 pF

C0G

ADC1-2

AIN1+,2+,3+,4+

4.7 µF

AIN1-,2-,3-,4-

Figure 28. Passive Input Filter w/Attenuation

52

DS717F1

Share Link: