CRD44800-ST-FB View Datasheet(PDF) - Cirrus Logic

Part Name

Description

Manufacturer

CRD44800-ST-FB

6-Channel Digital Amplifier Controller

Cirrus Logic 

CS44600

5. POWER SUPPLY, GROUNDING, AND PCB LAYOUT

The CS44600 requires a 2.5 V digital power supply for the core logic. In order to support a number of PWM backend

solutions, separate VDP power pins are provided to condition the interface signals to support up to 5.0 V levels. The

VDP power pins control the voltage levels for all PWM interface signals, PSR interface signals and GPIO for control

and status.

Extensive use of power and ground planes, ground plane fill in unused areas and surface mount decoupling capac-

itors are recommended. It is necessary to decouple the power supply by placing capacitors directly between the

power and ground of the CS44600. The recommended procedure is to place the lowest value capacitor as close as

physically possible to each power pin. Decoupling capacitors should be as near to the pins of the CS44600 as pos-

sible, with the low value ceramic capacitor being the nearest and mounted on the same side of the board as the

CS44600 to minimize inductance effects.

Figure 27 shows the recommended power supply decoupling layout. U1 is the CS44600. C2, C3, C6, C8, C10, C12,

C14, and C16 are 0.01 µF X7R capacitors. These should be placed as close as possible to their respective power

supply pins. C1, C4, C5, C7, C9, C11, C13, C15, and C17 are 0.1 µF X7R capacitors. C18 is a 10 µF electrolytic

capacitor. Top and bottom ground fill should be used as much as possible around all components shown.

Figure 27. Recommended CS44600 Power Supply Decoupling Layout

38

DS633F1

Share Link: