GAL26CV12C-7LP View Datasheet(PDF) - Lattice Semiconductor
Part Name
Description
Manufacturer
GAL26CV12C-7LP Datasheet PDF : 17 Pages
| |||
SpSepceifcicifaictaiotinosnsGGALA2L62C6VC1V21C2
Absolute Maximum Ratings(1)
Recommended Operating Conditions
Supply voltage V ...................................... –0.5 to +7V
CC
Input voltage applied .......................... –2.5 to VCC +1.0V
Off-state output voltage applied ......... –2.5 to VCC +1.0V
Storage Temperature ................................ –65 to 150°C
Ambient Temperature with
Power Applied ........................................... –55 to 125°C
1. Stresses above those listed under the “Absolute Maximum
Ratings” may cause permanent damage to the device. These
are stress only ratings and functional operation of the device at
these or at any other conditions above those indicated in the op-
erational sections of this specification is not implied (while pro-
gramming, follow the programming specifications).
Commercial Devices:
Ambient Temperature (TA) ............................. 0 to +75°C
Supply voltage (VCC)
with Respect to Ground ..................... +4.75 to +5.25V
Industrial Devices:
Ambient
Temperature
(T )
A
...........................
–40
to
85°C
Supply voltage (VCC)
with Respect to Ground ......................... +4.5 to +5.5V
DC Electrical Characteristics
Over Recommended Operating Conditions (Unless Otherwise Specified)
SYMBOL PARAMETER
CONDITION
MIN. TYP.3 MAX. UNITS
VIL
Input Low Voltage
VIH
Input High Voltage
IIL1
Input or I/O Low Leakage Current 0V ≤ VIN ≤ VIL (MAX.)
IIH
Input or I/O High Leakage Current 3.5V ≤ VIN ≤ VCC
VOL
Output Low Voltage
IOL = MAX. Vin = VIL or VIH
VOH
Output High Voltage
IOH = MAX. Vin = VIL or VIH
IOL
Low Level Output Current
IOH
High Level Output Current
IOS2
Output Short Circuit Current
COMMERCIAL
VCC = 5V VOUT = 0.5V TA = 25°C
ICC
Operating Power VIL = 0.5V VIH = 3.0V ftoggle = 15MHz
L-7
Supply Current
Outputs Open
INDUSTRIAL
ICC
Operating Power VIL = 0.5V VIH = 3.0V ftoggle = 15MHz
L-10
Supply Current
Outputs Open
Vss – 0.5 —
2.0
—
—
—
—
—
—
—
2.4
—
—
—
—
—
–30
—
0.8
V
Vcc+1 V
–100 µA
10
µA
0.5
V
—
V
16
mA
–3.2 mA
–130 mA
—
90
130
mA
—
90
150
mA
1) The leakage current is due to the internal pull-up on all pins. See Input Buffer section for more information.
2) One output at a time for a maximum duration of one second. Vout = 0.5V was selected to avoid test problems caused by tester
ground degradation. Characterized but not 100% tested.
3) Typical values are at Vcc = 5V and TA = 25 °C.
6
Share Link: 