L6208PD View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

L6208PD

DMOS driver for bipolar stepper motor

STMicroelectronics 

PWM current control

L6208

Therefore:

Equation 3

tOFF(MIN) = 6.6 µs

tOFF(MAX) = 6 ms

These values allow a sufficient range of tOFF to implement the drive circuit for most motors.

The capacitor value chosen for COFF also affects the rise time tRCRISE of the voltage at the

pin RCOFF. The rise time tRCRISE will only be an issue if the capacitor is not completely

charged before the next time the monostable is triggered. Therefore, the on time tON, which

depends by motors and supply parameters, has to be bigger than tRCRISE for allowing

a good current regulation by the PWM stage. Furthermore, the on time tON can not be

smaller than the minimum on time tON(MIN).

Equation 4

tON > tONMIN = 1.5s (typ. value)





tON > tRCRISE – tDT

tRCRISE = 600 · COFF

Figure 15 shows the lower limit for the on time tON for having a good PWM current

regulation capacity. It has to be said that tON is always bigger than tON(MIN) because the

device imposes this condition, but it can be smaller than tRCRISE - tDT. In this last case the

device continues to work but the off time tOFF is not more constant.

So, small COFF value gives more flexibility for the applications (allows smaller on time and,

therefore, higher switching frequency), but, the smaller is the value for COFF, the more

influential will be the noises on the circuit performance.

Figure 14. tOFF versus COFF and ROFF

 

52)) N

 

)

52))  N

52))  N





16/35









&R))>Q)@

DocID7514 Rev 2



$0

Share Link: