ST92124JCR1TC View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST92124JCR1TC

8/16-BIT SINGLE VOLTAGE FLASH MCU FAMILY WITH RAM, E³ ™ (EMULATED EEPROM), CAN 2.0B AND J1850 BLPD

STMicroelectronics 

CONTROLLER AREA NETWORK (bxCAN)

CONTROLLER AREA NETWORK (Cont’d)

– The transmit interrupt can be generated by the

following events:

– Transmit mailbox 0 becomes empty, RQCP0

bit in the CTSR register set.

– Transmit mailbox 1 becomes empty, RQCP1

bit in the CTSR register set.

– Transmit mailbox 2 becomes empty, RQCP2

bit in the CTSR register set.

– The FIFO 0 interrupt can be generated by the

following events:

– Reception of a new message, FMP bits in the

CRFR0 register incremented.

– FIFO0 full condition, FULL bit in the CRFR0

register set.

– FIFO0 overrun condition, FOVR bit in the

CRFR0 register set.

– The FIFO 1 interrupt can be generated by the

following events:

– Reception of a new message, FMP bits in the

CRFR1 register incremented.

– FIFO1 full condition, FULL bit in the CRFR1

register set.

– FIFO1 overrun condition, FOVR bit in the

CRFR1 register set.

– The error and status change interrupt can be

generated by the following events:

– Error condition, for more details on error con-

ditions please refer to the CAN Error Status

register (CESR).

– Wake-up condition, SOF monitored on the

CAN Rx signal.

10.10.7 Register Access Protection

Erroneous access to certain configuration regis-

ters can cause the hardware to temporarily disturb

the whole CAN network. Therefore the following

registers can be modified by software only while

the hardware is in initialization mode:

CBTR0, CBTR1, CFCR0, CFCR1, CFMR and

CDGR registers.

Although the transmission of incorrect data will not

cause problems at the CAN network level, it can

severely disturb the application. A transmit mail-

box can be only modified by software while it is in

empty state, refer to Figure 147.Transmit Mailbox

States

The filters must be deactivated before their value

can be modified by software. The modification of

the filter configuration (scale or mode) can be

done by software only in initialization mode.

342/429

9

Share Link: