LT3640IUFD View Datasheet(PDF) - Linear Technology
Part Name
Description
Manufacturer
LT3640IUFD Datasheet PDF : 24 Pages
| |||
LT3640
Applications Information
BST and SW Pin Considerations
The high voltage channel requires an external capacitor
between the BST and SW pins and an external boost diode
from a voltage source to the BST pin. In most cases, a
0.22µF capacitor will work well. The (BST-SW) voltage
cannot exceed 5.5V, and must be more than 2.3V for best
efficiency. Connect the boost diode to any voltage between
2.7V and 5.5V. The VIN2 pin is the best choice if the low
voltage channel is used.
The high voltage channel will not start until the (BST-SW)
voltage is 2V or above. When the LT3640 is enabled, an
internal ~5mA current source from VIN flows out of the BST
pin. The SW pin is disconnected from the SW1 pin, and is
pulled down by an internal current source to ground. The
external boost capacitor can be charged up regardless of
the output. When the (BST-SW) voltage reaches 2V, the SW
pin is connected to the SW1 pin, and the high voltage chan-
nel starts switching. However, the internal bipolar power
switch cannot be fully saturated until the (BST-SW) voltage
is further charged to above 2.3V. To start up a traditional
nonsynchronous buck regulator with very light load, the
input voltage needs to be a couple of volts higher than
the minimum running input voltage if the input voltage is
ramping up slowly. The LT3640’s unique boost capacitor
charging scheme solves this start-up issue. Figure 3 shows
that the minimum input voltage to start the high voltage
channel nonsynchronous buck regulator of the LT3640 is
very close to the minimum input voltage to regulate the
output voltage for most of the load range.
Soft-Start
The LT3640 has a soft-start pin for each channel. The
feedback pin voltage is regulated to the lower of the cor-
responding SS pin and the internal references, which is
1.265V for the high voltage channel, and 600mV for the low
voltage channel. A capacitor from the SS pin to ground is
charged by an internal 2µA current source resulting in an
output ramping linearly from 0V to the regulated voltage.
The duration of the ramp is:
t SS1
=
CSS1
•
1.265V
2µA
tSS2 = CSS2 •
600mV
2µA
where tSS1 is the ramping time for the SS1 pin, tSS2 is
the ramping time for the SS2 pin, CSS1 is the capacitance
from the SS1 pin to ground, and CSS2 is the capacitance
from the SS2 pin to ground.
At power-up, a latch is set to discharge the SS1 pin.
After the SS1 pin is discharged to below 100mV, the latch
is reset. The internal 2µA current source starts to charge
the SS1 pin when the (BST-SW) voltage is charged to
above 2V.
5
START
4
RUN
3
5
START
4
RUN
3
2
2
1
1
0
0.001
0.01
0.1
VOUT CURRENT (A)
1
3640 F03a
0
0.001
0.01
0.1
VOUT CURRENT (A)
(3a) FS = 2MHz
(3b) FS = 500kHz
Figure 3. High Voltage Channel Minimum Input Voltage for VOUT1 = 3.3V
1
3640 F03b
3640f
16
Share Link: 