M25PE80-VMN6TP View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

M25PE80-VMN6TP

8 Mbit, low-voltage, Page-Erasable Serial Flash memory with byte alterability, 50 MHz SPI bus, standard pinout

STMicroelectronics 

Instructions

M25PE80

6.11

Write to Lock Register (WRLR)

The Write to Lock Register (WRLR) instruction allows bits to be changed in the Lock

Registers. Before it can be accepted, a Write Enable (WREN) instruction must previously

have been executed. After the Write Enable (WREN) instruction has been decoded, the

device sets the Write Enable Latch (WEL).

The Write to Lock Register (WRLR) instruction is entered by driving Chip Select (S) Low,

followed by the instruction code, three address Bytes (pointing to any address in the

targeted sector and one data Byte on Serial Data Input (D). The instruction sequence is

shown in Figure 17. Chip Select (S) must be driven High after the eighth bit of the data Byte

has been latched in, otherwise the Write to Lock Register (WRLR) instruction is not

executed.

Lock Register bits are volatile, and therefore do not require time to be written. When the

Write to Lock Register (WRLR) instruction has been successfully executed, the Write

Enable Latch (WEL) bit is reset after a delay time less than tSHSL minimum value.

Any Write to Lock Register (WRLR) instruction, while an Erase, Program or Write cycle is in

progress, is rejected without having any effects on the cycle that is in progress.

Figure 17. Write to Lock Register (WRLR) instruction sequence

S

0 1 2 3 4 5 6 7 8 9 10 28 29 30 31 32 33 34 35 36 37 38 39

C

Instruction

24-Bit Address

Lock Register

In

D

23 22 21 3 2 1 0 7 6 5 4 3 2 1 0

MSB

MSB

AI10784

Table 12. Lock Register In(1)

Sector

Bit

Value

All Sectors in T9HX process

All Sectors except for Sector 0

and Sector 15 in T7Y process

b7-b2

‘0’

b1 Sector Lock Down Bit Value (refer to Table 11)

b0 Sector Write Lock Bit Value (refer to Table 11)

1. The table rows in gray are true for products processed in the T7Y process only (see Important note on

page 6).

36/61

Share Link: