P89LPC9301(2009) View Datasheet(PDF) - NXP Semiconductors.

Part Name

Description

Manufacturer

P89LPC9301
(Rev.:2009)

8-bit microcontroller with accelerated two-clock 80C51 core 4 kB/8 kB 3 V byte-erasable flash

NXP Semiconductors. 

NXP Semiconductors

P89LPC9301/931A1

8-bit microcontroller with accelerated two-clock 80C51 core

Table 10. Static characteristics …continued

VDD = 2.4 V to 3.6 V unless otherwise specified.

Tamb = −40 °C to +85 °C for industrial applications, unless otherwise specified.

Symbol Parameter

Conditions

Min

ITHL

HIGH-LOW transition

current

RRST_N(int) internal pull-up resistance

on pin RST

all ports; VI = 1.5 V at

VDD = 3.6 V

pin RST

[11] −30

10

Vref(bg)

TCbg

band gap reference voltage

band gap temperature

coefficient

1.11

-

Typ[1]

-

-

1.23

10

Max

−450

30

1.34

20

Unit

µA

kΩ

V

ppm/

°C

[1] Typical ratings are not guaranteed. The values listed are at room temperature, 3 V.

[2] The IDD(oper) specification is measured using an external clock with code while(1) {} executed from on-chip flash.

[3] The IDD(idle) specification is measured using an external clock with no active peripherals, with the following functions disabled: real-time

clock and watchdog timer.

[4] The IDD(pd) specification is measured using internal RC oscillator with the following functions disabled: comparators, real-time clock, and

watchdog timer.

[5] The IDD(tpd) specification is measured using an external clock with the following functions disabled: comparators, real-time clock,

brownout detect, and watchdog timer.

[6] See Section 8 “Limiting values” for steady state (non-transient) limits on IOL or IOH. If IOL/IOH exceeds the test condition, VOL/VOH may

exceed the related specification.

[7] This specification can be applied to pins which have A/D input or analog comparator input functions when the pin is not being used for

those analog functions. When the pin is being used as an analog input pin, the maximum voltage on the pin must be limited to 4.0 V with

respect to VSS.

[8] Pin capacitance is characterized but not tested.

[9] Measured with port in quasi-bidirectional mode.

[10] Measured with port in high-impedance mode.

[11] Port pins source a transition current when used in quasi-bidirectional mode and externally driven from logic 1 to logic 0. This current is

highest when VI is approximately 2 V.

P89LPC9301_931A1_1

Preliminary data sheet

Rev. 01 — 9 April 2009

© NXP B.V. 2009. All rights reserved.

43 of 65

Share Link: