PIC16C923T-04I/L View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
PIC16C923T-04I/L Datasheet PDF : 189 Pages
| |||
PIC16C9XX
13.5 Voltage Generation
There are two methods for LCD voltage generation,
internal charge pump, or external resistor ladder.
2*VLCD1 and VLCD3 = 3 * VLCD1. When the charge pump
is not operating, Vlcd3 will be internally tied to VDD. See
the Electrical Specifications section for charge pump
capacitor and potentiometer values.
13.5.1 CHARGE PUMP
13.5.2 EXTERNAL R-LADDER
The LCD charge pump is shown in Figure 13-13. The
1.0V - 2.3V regulator will establish a stable base volt-
age from the varying battery voltage. This regulator is
adjustable through the range by connecting a variable
external resistor from VLCDADJ to ground. The poten-
tiometer provides contrast adjustment for the LCD. This
base voltage is connected to VLCD1 on the charge
pump. The charge pump boosts VLCD1 into VLCD2 =
The LCD module can also use an external resistor lad-
der (R-Ladder) to generate the LCD voltages.
Figure 13-13 shows external connections for static and
1/3 bias. The VGEN (LCDCON<4>) bit must be cleared
to use an external R-Ladder.
FIGURE 13-13:CHARGE PUMP AND RESISTOR LADDER
VDD
10 µA
nominal
Charge Pump
LCDEN
SLPEN
VLCDADJ
100k*
130k*
VLCD3
VLCD2
VLCD1
0.47 µF*
0.47 µF*
0.47 µF*
10k*
VDD
10k*
10k*
C1 C2
0.47 µF*
Connections for
internal charge
pump, VGEN = 1
Connections for
external R-ladder,
1/3 Bias,
5k*
VGEN = 0
10k*
VDD
* These values are provided for design guidance only and should be
optimized to the application by the designer.
Connections for
external R-ladder,
Static Bias,
5k*
VGEN = 0
© 1997 Microchip Technology Inc.
DS30444E - page 101
Share Link: 