PIC16C57C-20I/P View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16C57C-20I/P

EPROM/ROM-Based 8-bit CMOS Microcontroller Series

Microchip Technology 

PIC16C5X

15.1 DC Characteristics: PIC16C54A-04, 10, 20 (Commercial)

PIC16C54A-04I, 10I, 20I (Industrial)

PIC16LC54A-04 (Commercial)

PIC16LC54A-04I (Industrial)

PIC16LC54A-04

PIC16LC54A-04I

(Commercial, Industrial)

Standard Operating Conditions (unless otherwise specified)

Operating Temperature 0°C  TA  +70°C for commercial

–40°C  TA  +85°C for industrial

PIC16C54A-04, 10, 20

PIC16C54A-04I, 10I, 20I

(Commercial, Industrial)

Standard Operating Conditions (unless otherwise specified)

Operating Temperature 0°C  TA  +70°C for commercial

–40°C  TA  +85°C for industrial

Param

No.

Symbol

Characteristic/Device

Min Typ† Max Units

Conditions

IPD Power-down Current(2)

D006

PIC16LC5X —

—

—

—

2.5 12 A VDD = 2.5V, WDT enabled, Commercial

0.25 4.0 A VDD = 2.5V, WDT disabled, Commercial

2.5 14 A VDD = 2.5V, WDT enabled, Industrial

0.25 5.0 A VDD = 2.5V, WDT disabled, Industrial

D006A

PIC16C5X —

—

—

—

4.0 12 A VDD = 3.0V, WDT enabled, Commercial

0.25 4.0 A VDD = 3.0V, WDT disabled, Commercial

5.0 14 A VDD = 3.0V, WDT enabled, Industrial

0.3 5.0 A VDD = 3.0V, WDT disabled, Industrial

Legend: Rows with standard voltage device data only are shaded for improved readability.

* These parameters are characterized but not tested.

† Data in “Typ” column is based on characterization results at 25°C. This data is for design guidance only and

is not tested.

Note 1: This is the limit to which VDD can be lowered in SLEEP mode without losing RAM data.

2: The supply current is mainly a function of the operating voltage and frequency. Other factors such as bus

loading, oscillator type, bus rate, internal code execution pattern and temperature also have an impact on

the current consumption.

a) The test conditions for all IDD measurements in active Operation mode are: OSC1 = external square

wave, from rail-to-rail; all I/O pins tristated, pulled to VSS, T0CKI = VDD, MCLR = VDD; WDT enabled/

disabled as specified.

b) For standby current measurements, the conditions are the same, except that the device is in SLEEP

mode. The power-down current in SLEEP mode does not depend on the oscillator type.

3: Does not include current through REXT. The current through the resistor can be estimated by the formula:

IR = VDD/2REXT (mA) with REXT in k.

 1997-2013 Microchip Technology Inc.

Preliminary

DS30453E-page 105

Share Link: