PIC16LCR63-04/PQ View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
PIC16LCR63-04/PQ Datasheet PDF : 336 Pages
| |||
PIC16C6X
Applicable Devices 61 62 62A R62 63 R63 64 64A R64 65 65A R65 66 67
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40˚C ≤ TA ≤ +125˚C for extended,
DC CHARACTERISTICS
-40˚C ≤ TA ≤ +85˚C for industrial and
0˚C ≤ TA ≤ +70˚C for commercial
Operating voltage VDD range as described in DC spec Section 23.1 and
Section 23.2
Param
Characteristic
Sym Min Typ Max Units
Conditions
No.
†
Output High Voltage
D090 I/O ports (Note 3)
VOH VDD-0.7 -
-
V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D090A
VDD-0.7 -
-
V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092 OSC2/CLKOUT (RC osc config)
VDD-0.7 -
-
V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D092A
VDD-0.7 -
-
V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D150* Open-Drain High Voltage
VOD
-
- 14
V RA4 pin
Capacitive Loading Specs on Out-
put Pins
D100 OSC2 pin
COSC2
-
- 15
pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 All I/O pins and OSC2 (in RC mode) CIO
-
- 50
pF
D102 SCL, SDA in I2C mode
Cb
-
- 400 pF
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16C6X be driven with external clock in RC mode.
2: The leakage current on the MCLR/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input volt-
ages.
3: Negative current is defined as current sourced by the pin.
© 1997 Microchip Technology Inc.
DS30234D-page 267
Share Link: 