PIC16LC774T-I/PT View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16LC774T-I/PT

28/40-Pin, 8-Bit CMOS Microcontrollers w/ 12-Bit A/D

Microchip Technology 

PIC16C77X

2.2.2.7 PIR2 REGISTER

This register contains the CCP2, SSP Bus Collision,

and Low-voltage detect interrupt flag bits.

.

Note:

Interrupt flag bits get set when an interrupt

condition occurs regardless of the state of

its corresponding enable bit or the global

enable bit, GIE (INTCON<7>). User soft-

ware should ensure the appropriate inter-

rupt flag bits are clear prior to enabling an

interrupt.

FIGURE 2-9: PIR2 REGISTER (ADDRESS 0Dh)

R/W-0

LVDIF

bit7

bit 7:

U-0

U-0

U-0

R/W-0

U-0

U-0

R/W-0

—

—

—

BCLIF

—

—

CCP2IF R = Readable bit

bit0 W = Writable bit

U = Unimplemented bit,

read as ‘0’

- n = Value at POR reset

LVDIF: Low-voltage Detect Interrupt Flag bit

1 = The supply voltage has fallen below the specified LVD voltage (must be cleared in software)

0 = The supply voltage is greater than the specified LVD voltage

bit 6-4: Unimplemented: Read as '0'

bit 3:

BCLIF: Bus Collision Interrupt Flag bit

1 = A bus collision has occurred while the SSP module configured in I2C Master was transmitting

(must be cleared in software)

0 = No bus collision occurred

bit 2-1: Unimplemented: Read as '0'

bit 0: CCP2IF: CCP2 Interrupt Flag bit

Capture Mode

1 = A TMR1 register capture occurred (must be cleared in software)

0 = No TMR1 register capture occurred

Compare Mode

1 = A TMR1 register compare match occurred (must be cleared in software)

0 = No TMR1 register compare match occurred

PWM Mode

Unused

DS30275B-page 22

Advance Information

 1999-2013 Microchip Technology Inc.

Share Link: