PIC16F76T-I/SP View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16F76T-I/SP

28/40-pin, 8-bit CMOS FLASH Microcontrollers

Microchip Technology 

PIC16F7X

15.2 DC Characteristics: PIC16F73/74/76/77 (Industrial, Extended)

PIC16LF73/74/76/77 (Industrial)

DC CHARACTERISTICS

Param

No.

Sym

Characteristic

Standard Operating Conditions (unless otherwise stated)

Operating temperature -40°C ≤ TA ≤ +85°C for industrial

-40°C ≤ TA ≤ +125°C for extended

Operating voltage VDD range as described in DC Specification,

Section 15.1.

Min Typ† Max Units

Conditions

VIL Input Low Voltage

I/O ports:

D030

with TTL buffer

VSS — 0.15VDD V For entire VDD range

D030A

VSS — 0.8V V 4.5V ≤ VDD ≤ 5.5V

D031

with Schmitt Trigger buffer VSS — 0.2VDD V

D032

D033

VIH

D040

D040A

D041

MCLR, OSC1 (in RC mode)

VSS

— 0.2VDD

OSC1 (in XT and LP mode)

VSS — 0.3V

OSC1 (in HS mode)

VSS

— 0.3VDD

Input High Voltage

I/O ports:

with TTL buffer

2.0

— VDD

0.25VDD — VDD

+ 0.8V

with Schmitt Trigger buffer 0.8VDD — VDD

V (Note 1)

V

V

V 4.5V ≤ VDD ≤ 5.5V

V For entire VDD range

V For entire VDD range

D042

MCLR

0.8VDD — VDD

D042A

OSC1 (in XT and LP mode)

1.6V — VDD

OSC1 (in HS mode)

0.7VDD — VDD

D043

OSC1 (in RC mode)

0.9VDD — VDD

D070 IPURB PORTB Weak Pull-up Current 50 250 400

IIL Input Leakage Current (Notes 2, 3)

D060

I/O ports

—

— ±1

V

V

V

V (Note 1)

µA VDD = 5V, VPIN = VSS

µA Vss ≤ VPIN ≤ VDD, pin at

hi-impedance

D061

D063

*

†

MCLR, RA4/T0CKI

—

—

±5

µA Vss ≤ VPIN ≤ VDD

OSC1

—

—

±5

µA Vss ≤ VPIN ≤ VDD, XT, HS and LP

osc configuration

These parameters are characterized but not tested.

Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance

only and are not tested.

Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the

PIC16F7X be driven with external clock in RC mode.

2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels

represent normal operating conditions. Higher leakage current may be measured at different input voltages.

3: Negative current is defined as current sourced by the pin.

 2002 Microchip Technology Inc.

DS30325B-page 123

Share Link: