PIC16F720T-E/SO View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
PIC16F720T-E/SO Datasheet PDF : 254 Pages
| |||
PIC16(L)F720/721
15.3 PWM Mode
The PWM mode generates a Pulse-Width Modulated
signal on the CCP1 pin. The duty cycle, period and
resolution are determined by the following registers:
• PR2
• T2CON
• CCPR1L
• CCP1CON
In Pulse-Width Modulation (PWM) mode, the CCP
module produces up to a 10-bit resolution PWM output
on the CCP1 pin.
Figure 15-3 shows a simplified block diagram of PWM
operation.
Figure 15-4 shows a typical waveform of the PWM
signal.
For a step-by-step procedure on how to set up the CCP
module for PWM operation, refer to Section 15.3.8
“Setup for PWM Operation”.
FIGURE 15-3:
SIMPLIFIED PWM BLOCK
DIAGRAM
Duty Cycle Registers
CCPR1L
CCP1CON<5:4>
The PWM output (Figure 15-4) has a time base
(period) and a time that the output stays high (duty
cycle).
FIGURE 15-4:
Period
CCP PWM OUTPUT
Pulse Width
TMR2 = 0
TMR2 = PR2
TMR2 = CCPR1L:CCP1CON<5:4>
15.3.1 CCPX PIN CONFIGURATION
In PWM mode, the CCP1 pin is multiplexed with the
PORT data latch. The user must configure the CCP1
pin as an output by clearing the associated TRIS bit.
Note: Clearing the CCP1CON register will
relinquish CCP1 control of the CCP1 pin.
CCPR1H(2) (Slave)
Comparator
RQ
CCP1
TMR2
(1)
S
TRIS
Comparator
PR2
Clear Timer2,
toggle CCP1 pin and
latch duty cycle
Note 1:
2:
The 8-bit timer TMR2 register is concatenated with
the 2-bit internal system clock (FOSC), or two bits of
the prescaler, to create the 10-bit time base.
In PWM mode, CCPR1H is a read-only register.
DS41430D-page 112
2010-2013 Microchip Technology Inc.
Share Link: 