PIC16F87T/ML View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16F87T/ML

18/20/28-Pin Enhanced Flash MCUs with nanoWatt Technology

Microchip Technology 

PIC16F87/88

11.2.3

SETTING UP 9-BIT MODE WITH

ADDRESS DETECT

When setting up an asynchronous reception with

address detect enabled:

• Initialize the SPBRG register for the appropriate

baud rate. If a high-speed baud rate is desired,

set bit BRGH.

• Enable the asynchronous serial port by clearing

bit SYNC and setting bit SPEN.

• If interrupts are desired, then set enable bit RCIE.

• Set bit RX9 to enable 9-bit reception.

• Set ADDEN to enable address detect.

• Enable the reception by setting enable bit CREN.

• Flag bit RCIF will be set when reception is

complete and an interrupt will be generated if

enable bit RCIE was set.

• Read the RCSTA register to get the ninth bit and

determine if any error occurred during reception.

• Read the 8-bit received data by reading the

RCREG register to determine if the device is

being addressed.

• If any error occurred, clear the error by clearing

enable bit CREN.

• If the device has been addressed, clear the

ADDEN bit to allow data bytes and address bytes

to be read into the receive buffer and interrupt the

CPU.

FIGURE 11-6:

AUSART RECEIVE BLOCK DIAGRAM

FOSC

x64 Baud Rate CLK

SPBRG

Baud Rate Generator

CREN

 64

or

 16

OERR

FERR

MSb

RSR Register

Stop (8) 7  1

LSb

0 Start

RB2/SDO/RX/DT

Pin Buffer

and Control

Data

Recovery

RX9

8

SPEN

RX9

ADDEN

RX9

ADDEN

RSR<8>

Enable

Load of

Receive

Buffer

8

RX9D

RCREG Register

FIFO

Interrupt

RCIF

RCIE

8

Data Bus

DS30487D-page 106

 2002-2013 Microchip Technology Inc.

Share Link: