PIC16C71T-04/SP View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16C71T-04/SP

8-Bit CMOS Microcontrollers with A/D Converter

Microchip Technology 

PIC16C71X

FIGURE 8-14: EXTERNAL POWER-ON

RESET CIRCUIT (FOR SLOW

VDD POWER-UP)

VDD

D

R

C

R1

MCLR

PIC16CXX

Note 1: External Power-on Reset circuit is

required only if VDD power-up slope is too

slow. The diode D helps discharge the

capacitor quickly when VDD powers down.

2: R < 40 kΩ is recommended to make sure

that voltage drop across R does not violate

the device’s electrical specification.

3: R1 = 100Ω to 1 kΩ will limit any current

flowing into MCLR from external capacitor

C in the event of MCLR/VPP pin break-

down due to Electrostatic Discharge

(ESD) or Electrical Overstress (EOS).

FIGURE 8-15: EXTERNAL BROWN-OUT

PROTECTION CIRCUIT 1

VDD

33k

VDD

10k

MCLR

40k PIC16CXX

Note 1: This circuit will activate reset when VDD

goes below (Vz + 0.7V) where Vz = Zener

voltage.

2: Internal brown-out detection on the

PIC16C710/711/715 should be disabled

when using this circuit.

3: Resistors should be adjusted for the char-

acteristics of the transistor.

FIGURE 8-16: EXTERNAL BROWN-OUT

PROTECTION CIRCUIT 2

VDD

R1

R2

VDD

Q1

MCLR

40k PIC16CXX

Note 1: This brown-out circuit is less expensive,

albeit less accurate. Transistor Q1 turns

off when VDD is below a certain level

such that:

VDD •

R1 = 0.7V

R1 + R2

2: Internal brown-out detection on the

PIC16C710/711/715 should be disabled

when using this circuit.

3: Resistors should be adjusted for the

characteristics of the transistor.

DS30272A-page 60

© 1997 Microchip Technology Inc.

Share Link: