PIC16LC71T-20E/SO View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16LC71T-20E/SO

8-Bit CMOS Microcontrollers with A/D Converter

Microchip Technology 

PIC16C71X

Applicable Devices 710 71 711 715

DC CHARACTERISTICS

Standard Operating Conditions (unless otherwise stated)

Operating temperature 0˚C ≤ TA ≤ +70˚C (commercial)

-40˚C ≤ TA ≤ +85˚C (industrial)

-40˚C ≤ TA ≤ +125˚C (extended)

Operating voltage VDD range as described in DC spec Section 11.1 and

Section 11.2.

Param

Characteristic

Sym Min Typ Max Units

Conditions

No.

†

Output Low Voltage

D080 I/O ports

VOL

-

- 0.6

V IOL = 8.5 mA, VDD = 4.5V,

-40°C to +85°C

D080A

-

- 0.6

V IOL = 7.0 mA, VDD = 4.5V,

-40°C to +125°C

D083 OSC2/CLKOUT (RC osc config)

-

- 0.6

V IOL = 1.6 mA, VDD = 4.5V,

-40°C to +85°C

D083A

-

- 0.6

V IOL = 1.2 mA, VDD = 4.5V,

-40°C to +125°C

Output High Voltage

D090 I/O ports (Note 3)

VOH VDD - 0.7 -

-

V IOH = -3.0 mA, VDD = 4.5V,

-40°C to +85°C

D090A

VDD - 0.7 -

-

V IOH = -2.5 mA, VDD = 4.5V,

-40°C to +125°C

D092 OSC2/CLKOUT (RC osc config)

VDD - 0.7 -

-

V IOH = -1.3 mA, VDD = 4.5V,

-40°C to +85°C

D092A

VDD - 0.7 -

-

V IOH = -1.0 mA, VDD = 4.5V,

-40°C to +125°C

D130* Open-Drain High Voltage

VOD

-

- 14

V RA4 pin

Capacitive Loading Specs on

Output Pins

D100 OSC2 pin

COSC2

-

- 15 pF In XT, HS and LP modes when

external clock is used to drive

OSC1.

D101 All I/O pins and OSC2 (in RC mode) CIO

-

- 50 pF

* These parameters are characterized but not tested.

† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only

and are not tested.

Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the

PIC16C7X be driven with external clock in RC mode.

2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. The specified levels

represent normal operating conditions. Higher leakage current may be measured at different input voltages.

3: Negative current is defined as current sourced by the pin.

© 1997 Microchip Technology Inc.

DS30272A-page 93

Share Link: