PIC16LF1513 View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16LF1513

28-Pin Flash Microcontrollers with XLP Technology

Microchip Technology 

PIC16(L)F1512/3

20.6.13.3 Bus Collision During a Stop

Condition

Bus collision occurs during a Stop condition if:

a) After the SDA pin has been deasserted and

allowed to float high, SDA is sampled low after

the BRG has timed out.

b) After the SCL pin is deasserted, SCL is sampled

low before SDA goes high.

The Stop condition begins with SDA asserted low.

When SDA is sampled low, the SCL pin is allowed to

float. When the pin is sampled high (clock arbitration),

the Baud Rate Generator is loaded with SSPADD and

counts down to zero. After the BRG times out, SDA is

sampled. If SDA is sampled low, a bus collision has

occurred. This is due to another master attempting to

drive a data ‘0’ (Figure 20-37). If the SCL pin is sampled

low before SDA is allowed to float high, a bus collision

occurs. This is another case of another master

attempting to drive a data ‘0’ (Figure 20-38).

FIGURE 20-38:

BUS COLLISION DURING A STOP CONDITION (CASE 1)

TBRG

TBRG

TBRG

SDA

SCL

SDA asserted low

SDA sampled

low after TBRG,

set BCLIF

PEN

BCLIF

P

’0’

SSPIF

’0’

FIGURE 20-39: BUS COLLISION DURING A STOP CONDITION (CASE 2)

TBRG

TBRG

TBRG

SDA

SCL

Assert SDA

SCL goes low before SDA goes high,

set BCLIF

PEN

BCLIF

P

’0’

SSPIF

’0’

DS40001624C-page 220

 2012-2014 Microchip Technology Inc.

Share Link: