PIC18F4610-I/ML View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC18F4610-I/ML

28/40/44-Pin Flash Microcontrollers with 10-Bit A/D and nanoWatt Technology

Microchip Technology 

PIC18F2X1X/4X1X

REGISTER 16-5:

SSPCON2: MSSP CONTROL REGISTER 2 (I2C MODE)

R/W-0

GCEN

R/W-0

ACKSTAT

R/W-0

ACKDT

R/W-0 R/W-0 R/W-0

ACKEN(1) RCEN(1) PEN(1)

bit 7

R/W-0

RSEN(1)

R/W-0

SEN(1)

bit 0

bit 7 GCEN: General Call Enable bit (Slave mode only)

1 = Enable interrupt when a general call address (0000h) is received in the SSPSR

0 = General call address disabled

bit 6 ACKSTAT: Acknowledge Status bit (Master Transmit mode only)

1 = Acknowledge was not received from slave

0 = Acknowledge was received from slave

bit 5 ACKDT: Acknowledge Data bit (Master Receive mode only)

1 = Not Acknowledge

0 = Acknowledge

Note: Value that will be transmitted when the user initiates an Acknowledge sequence at

the end of a receive.

bit 4 ACKEN: Acknowledge Sequence Enable bit (Master Receive mode only)(1)

1 = Initiate Acknowledge sequence on SDA and SCL pins and transmit ACKDT data bit.

Automatically cleared by hardware.

0 = Acknowledge sequence Idle

bit 3 RCEN: Receive Enable bit (Master mode only)(1)

1 = Enables Receive mode for I2C operation

0 = Receive Idle

bit 2 PEN: Stop Condition Enable bit (Master mode only)(1)

1 = Initiate Stop condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Stop condition Idle

bit 1 RSEN: Repeated Start Condition Enable bit (Master mode only)(1)

1 = Initiate Repeated Start condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Repeated Start condition Idle

bit 0 SEN: Start Condition Enable/Stretch Enable bit(1)

In Master mode:

1 = Initiate Start condition on SDA and SCL pins. Automatically cleared by hardware.

0 = Start condition Idle

In Slave mode:

1 = Clock stretching is enabled for both slave transmit and slave receive (stretch enabled)

0 = Clock stretching is disabled

Note 1: For bits ACKEN, RCEN, PEN, RSEN, SEN: If the I2C module is not in the Idle mode,

these bits may not be set (no spooling) and the SSPBUF may not be written (or

writes to the SSPBUF are disabled).

Legend:

R = Readable bit

-n = Value at POR

W = Writable bit

‘1’ = Bit is set

U = Unimplemented bit, read as ‘0’

‘0’ = Bit is cleared x = Bit is unknown

© 2007 Microchip Technology Inc.

Preliminary

DS39636C-page 163

Share Link: