PIC16LC74AT-10/SP View Datasheet(PDF) - Microchip Technology

Part Name

Description

Manufacturer

PIC16LC74AT-10/SP

8-Bit CMOS Microcontrollers with A/D Converter

Microchip Technology 

PIC16C7X

Applicable Devices 72 73 73A 74 74A 76 77

Standard Operating Conditions (unless otherwise stated)

Operating temperature -40˚C ≤ TA ≤ +125˚C for extended,

DC CHARACTERISTICS

-40˚C ≤ TA ≤ +85˚C for industrial and

0˚C ≤ TA ≤ +70˚C for commercial

Operating voltage VDD range as described in DC spec Section 17.1

and Section 17.2.

Param

Characteristic

Sym Min Typ Max Units

Conditions

No.

†

Output High Voltage

D090

I/O ports (Note 3)

VOH VDD - 0.7 -

-

V IOH = -3.0 mA, VDD = 4.5V,

-40°C to +85°C

D090A

VDD - 0.7 -

-

V IOH = -2.5 mA, VDD = 4.5V,

-40°C to +125°C

D092

OSC2/CLKOUT (RC osc config)

VDD - 0.7 -

-

V IOH = -1.3 mA, VDD = 4.5V,

-40°C to +85°C

D092A

VDD - 0.7 -

-

V IOH = -1.0 mA, VDD = 4.5V,

-40°C to +125°C

D150*

Open-Drain High Voltage

VOD

-

- 14

V RA4 pin

Capacitive Loading Specs on Out-

put Pins

D100

OSC2 pin

COSC2

-

- 15 pF In XT, HS and LP modes

when external clock is used to

drive OSC1.

D101

All I/O pins and OSC2 (in RC mode) CIO

-

- 50 pF

D102

SCL, SDA in I2C mode

CB

-

- 400 pF

* These parameters are characterized but not tested.

† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only

and are not tested.

Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt trigger input. It is not recommended that the

PIC16C7X be driven with external clock in RC mode.

2: The leakage current on the MCLR/VPP pin is strongly dependent on the applied voltage level. The specified

levels represent normal operating conditions. Higher leakage current may be measured at different input volt-

ages.

3: Negative current is defined as current sourced by the pin.

© 1997 Microchip Technology Inc.

DS30390E-page 171

Share Link: