ST72F361J9T3 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST72F361J9T3

8-bit MCU with Flash or ROM, 10-bit ADC, 5 timers, SPI, 2x LINSCI™

STMicroelectronics 

ST72361

12 ELECTRICAL CHARACTERISTICS

12.1 PARAMETER CONDITIONS

Unless otherwise specified, all voltages are re-

ferred to VSS.

12.1.1 Minimum and Maximum Values

Unless otherwise specified the minimum and max-

imum values are guaranteed in the worst condi-

tions of ambient temperature, supply voltage and

frequencies by tests in production on 100% of the

devices with an ambient temperature at TA = 25°C

and TA = TAmax (given by the selected tempera-

ture range).

Data based on characterization results, design

simulation and/or technology characteristics are

indicated in the table footnotes and are not tested

in production. Based on characterization, the min-

imum and maximum values refer to sample tests

and represent the mean value plus or minus three

times the standard deviation (mean±3Σ).

12.1.2 Typical Values

Unless otherwise specified, typical data is based

on TA = 25°C, VDD = 5V (for the

4.5V ≤ VDD ≤ 5.5V voltage range). They are given

only as design guidelines and are not tested.

Typical ADC accuracy values are determined by

characterization of a batch of samples from a

standard diffusion lot over the full temperature

range, where 95% of the devices have an error

less than or equal to the value indicated

(mean±2Σ).

12.1.3 Typical Curves

Unless otherwise specified, all typical curves are

given only as design guidelines and are not tested.

12.1.4 Loading Capacitor

The loading conditions used for pin parameter

measurement are shown in Figure 95.

Figure 95. Pin Loading Conditions

12.1.5 Pin Input Voltage

The input voltage measurement on a pin of the de-

vice is described in Figure 96.

Figure 96. Pin input voltage

ST7 PIN

VIN

ST7 PIN

CL

178/224

Share Link: