STM32F030R8P6(2013) View Datasheet(PDF) - STMicroelectronics
Part Name
Description
Manufacturer
STM32F030R8P6
(Rev.:2013)
(Rev.:2013)
STMicroelectronics
STM32F030R8P6 Datasheet PDF : 88 Pages
| |||
STM32F030x4 STM32F030x6 STM32F030x8
Electrical characteristics
Symbol
Table 16. Current characteristics
Ratings
Max.
Unit
ï“IVDD
Total current into sum of all VDD_x and VDDSDx power lines
(source)(1)
120
ï“IVSS
Total current out of sum of all VSS_x and VSSSD ground lines
(sink)(1)
-120
IVDD(PIN)
IVSS(PIN)
Maximum current into each VDD_x or VDDSDx power pin (source)(1)
Maximum current out of each VSS_x or VSSSD ground pin (sink)(1)
100
-100
IIO(PIN)
Output current sunk by any I/O and control pin
Output current source by any I/O and control pin
25
-25
mA
Total output current sunk by sum of all IOs and control pins(2)
80
ï“IIO(PIN)
Total output current sourced by sum of all IOs and control pins(2)
-80
Injected current on FT, FTf and B pins(3)
-5/+0
IINJ(PIN)
Injected current on TC and RST pin(4)
±5
Injected current on TTa pins(5)
±5
ï“IINJ(PIN)
Total injected current (sum of all I/O and control pins)(6)
± 25
1. All main power (VDD, VDDA) and ground (VSS, VSSA) pins must always be connected to the external power
supply, in the permitted range.
2. This current consumption must be correctly distributed over all I/Os and control pins. The total output current
must not be sunk/sourced between two consecutive power supply pins referring to high pin count QFP
packages.
3. Positive injection is not possible on these I/Os and does not occur for input voltages lower than the specified
maximum value.
4. A positive injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. IINJ(PIN) must
never be exceeded. Refer to Table 15: Voltage characteristics for the maximum allowed input voltage values.
5. A positive injection is induced by VIN>VDDA while a negative injection is induced by VIN<VSS. IINJ(PIN) must
never be exceeded. Refer also to Table 15: Voltage characteristics for the maximum allowed input voltage
values. Negative injection disturbs the analog performance of the device. See note (2) below Table 50: ADC
accuracy.
6. When several inputs are submitted to a current injection, the maximum ï“IINJ(PIN) is the absolute sum of the
positive and negative injected currents (instantaneous values).
Table 17. Thermal characteristics
Symbol
Ratings
Value
Unit
TSTG
TJ
Storage temperature range
Maximum junction temperature
–65 to +150
°C
150
°C
DocID024849 Rev 1
39/88
73
Share Link: 