STM32F030K8T6 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F030K8T6

Value-line ARM®-based 32-bit MCU with up to 256-KB Flash, timers, ADC, communication interfaces, 2.4-3.6 V operation

STMicroelectronics 

Electrical characteristics

STM32F030x4/x6/x8/xC

Symbol

Table 27. Typical and maximum consumption in Stop and Standby modes

Parameter

Conditions

Typ @VDD

(VDD = VDDA)

Max(1)

Unit

3.6 V

TA = 85 °C

Supply current in Regulator in run mode, all oscillators OFF

19

Stop mode

IDD

Regulator in low-power mode, all oscillators OFF

5

Supply current in

Standby mode

LSI ON and IWDG ON

2

Supply current in

Stop mode

Regulator in run or low-

power mode, all

2.9

oscillators OFF

Supply current in VDDA monitoring ON LSI ON and IWDG ON

3.3

Standby mode

LSI OFF and IWDG OFF

2.8

IDDA

Supply current in

Stop mode

Regulator in run or low-

power mode, all

1.7

oscillators OFF

Supply current in VDDA monitoring OFF LSI ON and IWDG ON

2.3

Standby mode

LSI OFF and IWDG OFF

1.4

48

32

-

3.5

-

µA

3.5

-

-

-

1. Data based on characterization results, not tested in production unless otherwise specified.

Typical current consumption

The MCU is placed under the following conditions:

• VDD = VDDA = 3.3 V

• All I/O pins are in analog input configuration

• The Flash access time is adjusted to fHCLK frequency:

– 0 wait state and Prefetch OFF from 0 to 24 MHz

– 1 wait state and Prefetch ON above 24 MHz

• When the peripherals are enabled, fPCLK = fHCLK

• PLL is used for frequencies greater than 8 MHz

• AHB prescaler of 2, 4, 8 and 16 is used for the frequencies 4 MHz, 2 MHz, 1 MHz and

500 kHz respectively

48/91

DocID024849 Rev 3

Share Link: