TDA7564BPD View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

TDA7564BPD

4 x 50W multifunction quad power amplifier with built-in diagnostics features

STMicroelectronics 

TDA7564B

5

Multiple faults

Multiple faults

When more misconnections are simultaneously in place at the audio outputs, it is

guaranteed that at least one of them is initially read out. The others are notified after

successive cycles of I2C reading and faults removal, provided that the diagnostic is enabled.

This is true for both kinds of diagnostic (Turn on and Permanent).

The table below shows all the couples of double-fault possible. It should be taken into

account that a short circuit with the 4 ohm speaker unconnected is considered as double

fault.

Table 5.

Double fault table for turn-on diagnostic

S. GND (so) S. GND (sk)

S. Vs

S. GND (so)

S. GND (sk)

S. GND

/

S. GND

S. GND

S. Vs + S.

GND

S. Vs

S. Vs

/

/

S. Vs

S. Across L.

/

/

/

Open L.

/

/

/

S. Across L.

Open L.

S. GND

S. GND

S. GND

S. Vs

S. Across L.

/

Open L. (*)

S. Vs

N.A.

Open L. (*)

S. GND (so) / S. GND (sk) in the above table make a distinction according to which of the 2

outputs is shorted to ground (test-current source side= so, test-current sink side = sk). More

precisely, in Channels LF and RR, so = CH+, sk = CH-; in Channels LR and RF, so = CH-, sk

= CH+.

In Permanent Diagnostic the table is the same, with only a difference concerning Open

Load(*), which is not among the recognizable faults. Should an Open Load be present

during the device's normal working, it would be detected at a subsequent Turn on Diagnostic

cycle (i.e. at the successive Car Radio Turn on).

5.1

Faults availability

All the results coming from I2C bus, by read operations, are the consequence of

measurements inside a defined period of time. If the fault is stable throughout the whole

period, it will be sent out.

To guarantee always resident functions, every kind of diagnostic cycles (Turn on,

Permanent, Offset) will be reactivate after any I2C reading operation. So, when the micro

reads the I2C, a new cycle will be able to start, but the read data will come from the previous

diag. cycle (i.e. The device is in Turn On state, with a short to Gnd, then the short is

removed and micro reads I2C. The short to Gnd is still present in bytes, because it is the

result of the previous cycle. If another I2C reading operation occurs, the bytes do not show

the short). In general to observe a change in Diagnostic bytes, two I2C reading operations

are necessary.

19/34

Share Link: