TDA9112A View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

TDA9112A

HIGH-END I²C CONTROLLED DEFLECTION PROCESSOR FOR MULTISYNC MONITOR

STMicroelectronics 

Notes about Miscellaneous section

TDA9112A

Note 58: Current sunk by the pin if the external voltage is higher than one the circuit tries to force.

Note 59: See VRefO in Section 6.2.

Note 60: In the regions of VCC where the device’s operation is disabled, the H-drive, V-drive and B+-drive signals on

HOut, VOut and BOut pins, resp., are inhibited, the I²C-bus does not accept any data and the XRayAlarm flag

is reset. Also see Figure 10.

Note 61: See Figure 10.

Note 62: When VCC is below VCCXRayEn XRay detection and protection are disabled.

Note 63: Minimum momentary supply voltage to ensure a correct performance of Soft stop function at VCC fall down is

defined at the moment when the voltage on HPosF pin reaches VHOn threshold.

21/60

Share Link: