MCP6S22T-I/SL(2012) View Datasheet(PDF) - Microchip Technology
Part Name
Description
Manufacturer
MCP6S22T-I/SL Datasheet PDF : 42 Pages
| |||
MCP6S21/2/6/8
5.2 Registers
The analog functions are programmed through the SPI
interface using 16-bit words (see Figure 5-1 and
Figure 5-2). This data is sent to two of three 8-bit regis-
ters: Instruction Register (Register 5-1), Gain Register
(Register 5-2) and Channel Register (Register 5-3).
The power-up defaults for these three registers are:
• Instruction Register: 000x xxx0
• Gain Register: xxxx x000
• Channel Register: xxxx x000
REGISTER 5-1:
INSTRUCTION REGISTER
W-0
W-0
W-0
M2
M1
M0
bit 7
Thus, these devices are initially programmed with the
Instruction Register set for NOP (no operation), a gain
of +1 V/V and CH0 as the input channel.
5.2.1 INSTRUCTION REGISTER
The Instruction Register has 3 command bits and 1
indirect address bit; see Register 5-1. The command
bits include a NOP (000) to support daisy chaining (see
Section 5.3, “Registers”); the other NOP commands
shown should not be used (they are reserved for future
use). The device is brought out of Shutdown mode
when a valid command, other than NOP or Shutdown, is
sent and CS is raised.
U-x
U-x
U-x
U-x
W-0
—
—
—
—
A0
bit 0
bit 7-5
bit 4-1
bit 0
M2-M0: Command Bits
000 =
001 =
010 =
011 =
1XX =
NOP (Default) (Note 1)
PGA enters Shutdown Mode as soon as a full 16-bit word is sent and CS is raised.
(Notes 1 and 2)
Write to register.
NOP (reserved for future use) (Note 1)
NOP (reserved for future use) (Note 1)
Unimplemented: Read as ‘0’ (reserved for future use)
A0: Indirect Address Bit
1 = Addresses the Channel Register
0 = Addresses the Gain Register (Default)
Note 1: All other bits in the 16-bit word (including A0) are “don’t cares”.
2: The device exits Shutdown mode when a valid command (other than NOP or Shut-
down) is sent and CS is raised; that valid command will be executed. Shutdown
does not toggle.
Legend:
R = Readable bit
-n = Value at POR
W = Writable bit
’1’ = Bit is set
U = Unimplemented bit, read as ‘0’
’0’ = Bit is cleared x = Bit is unknown
2003-2012 Microchip Technology Inc.
DS21117B-page 19
Share Link: 