ST92F150CV1TBE View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST92F150CV1TBE

8/16-bit single voltage Flash MCU family with RAM, E³ ™ (emulated EEPROM), CAN 2.0B and J1850 BLPD

STMicroelectronics 

ST92124xxx-Auto/150xxxxx-Auto/250xxxx-Auto

Description

An I2C interface (two in the ST92250-Auto device) provides fast I2C and Access Bus

support.

The SPI is a synchronous serial interface for Master and Slave device communication. It

supports single master and multimaster systems.

A J1850 Byte Level Protocol Decoder is available (ST92150JDV1-Auto device only) for

communicating with a J1850 network.

The bxCAN (basic extended) interface (two in the ST92150JDV1-Auto device) supports

2.0B Active protocol. It has 3 transmit mailboxes, 2 independent receive FIFOs and 8 filters.

In addition, there is a 16 channel Analog to Digital Converter with integral sample and hold,

fast conversion time and 10-bit resolution.

There is one Multiprotocol Serial Communications Interface with an integral generator,

asynchronous and synchronous capability (fully programmable format) and associated

address/wake-up option, plus two DMA channels.

On 100-pin devices, there is an additional asynchronous Serial Communications interface

with 13-bit LIN Synch Break generation capability.

Finally, a programmable PLL Clock Generator allows the usage of standard 3 to 5 MHz

crystals to obtain a large range of internal frequencies up to 24 MHz. Low power Run

(SLOW), Wait For Interrupt, low power Wait For Interrupt, STOP and HALT modes are also

available.

Doc ID 13898 Rev 2

21/522

Share Link: