STM32F217RGH6 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F217RGH6

ARM-based 32-bit MCU, 150DMIPs, up to 1 MB Flash/128+4KB RAM, crypto, USB OTG HS/FS, Ethernet, 17 TIMs, 3 ADCs, 15 comm. interfaces & camera

STMicroelectronics 

STM32F21xxx

Application block diagrams

Figure 84. USB OTG FS (full speed) host-only connection

GPIO

GPIO+IRQ

STM32F20xx

VDD

EN

Overcurrent

Current limiter

power switch(1)

5 V Pwr

OSC_IN

OSC_OUT

PA9

PA11

PA12

VBUS

DM

DP

VSS

ai17296c

1. The current limiter is required only if the application has to support a VBUS powered device. A basic power

switch can be used if 5 V are available on the application board.

2. The same application can be developed using the OTG HS in FS mode to achieve enhanced performance

thanks to the large Rx/Tx FIFO and to a dedicated DMA controller.

Figure 85. OTG FS (full speed) connection dual-role with internal PHY

VDD

5 V to VDD

voltage regulator (1)

GPIO

GPIO+IRQ

EN

Overcurrent

VDD

Current limiter 5 V Pwr

power switch(2)

STM32F20xxx

OSC_IN

OSC_OUT

PA9

PA11

PA12

PA10

VBUS

DM

DP

ID(3)

VSS

ai17294c

1. External voltage regulator only needed when building a VBUS powered device.

2. The current limiter is required only if the application has to support a VBUS powered device. A basic power

switch can be used if 5 V are available on the application board.

3. The ID pin is required in dual role only.

4. The same application can be developed using the OTG HS in FS mode to achieve enhanced performance

thanks to the large Rx/Tx FIFO and to a dedicated DMA controller.

Doc ID 17050 Rev 8

155/173

Share Link: