TS80C54X2-LIB View Datasheet(PDF) - Atmel Corporation
Part Name
Description
Manufacturer
TS80C54X2-LIB Datasheet PDF : 58 Pages
| |||
TS80C54X2/C58X2
TS87C54X2/C58X2
PROGRAM
SIGNALS*
CONTROL
SIGNALS*
EA/VPP
ALE/PROG
RST
PSEN
P2.6
P2.7
P3.3
P3.6
P3.7
+5V
VCC
P0.0-P0.7
D0-D7
P1.0-P1.7
P2.0-P2.5,
P3.4
A0-A7
A8-A14
4 to 6 MHz
XTAL1
VSS
GND
* See Table 31. for proper value on these inputs
Figure 11. Set-Up Modes Configuration
8.3.3 Programming Algorithm
The Improved Quick Pulse algorithm is based on the Quick Pulse algorithm and decreases the number of pulses
applied during byte programming from 25 to 1.
To program the TS80C54/58X2 the following sequence must be exercised:
q Step 1: Activate the combination of control signals.
q Step 2: Input the valid address on the address lines.
q Step 3: Input the appropriate data on the data lines.
q Step 4: Raise EA/VPP from VCC to VPP (typical 12.75V).
q Step 5: Pulse ALE/PROG once.
q Step 6: Lower EA/VPP from VPP to VCC
Repeat step 2 through 6 changing the address and data for the entire array or until the end of the object file is
reached (See Figure 12.).
8.3.4 Verify algorithm
Code array verify must be done after each byte or block of bytes is programmed. In either case, a complete verify
of the programmed array will ensure reliable programming of the TS87C54/58X2.
P 2.7 is used to enable data output.
To verify the TS87C54/58X2 code the following sequence must be exercised:
q Step 1: Activate the combination of program and control signals.
q Step 2: Input the valid address on the address lines.
q Step 3: Read data on the data lines.
Repeat step 2 through 3 changing the address for the entire array verification (See Figure 12.)
The encryption array cannot be directly verified. Verification of the encryption array is done by observing that the
code array is well encrypted.
38
Rev. C - 15 January, 2001
Share Link: 