STM32F051C4T7TR View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F051C4T7TR

ARM®-based 32-bit MCU, 16 to 64 KB Flash, 11 timers, ADC, DAC and communication interfaces, 2.0-3.6 V

STMicroelectronics 

Revision history

STM32F051x4 STM32F051x6 STM32F051x8

Date

13-Jan-2014

Table 76. Document revision history (continued)

Revision

Changes

4

(continued)

Added “Negative induced leakage current is caused by negative

injection and positive induced leakage current is caused by

positive injection” in Section Functional susceptibility to I/O

current injection.

Replaced reference "JESD22-C101" with "ANSI/ESD

STM5.3.1" in Table : ESD absolute maximum ratings.

Merged Table: Typical and maximum VDD consumption in Stop

and Standby modes and Table: Typical and maximum VDDA

consumption in Stop and Standby modes into Table: Typical and

maximum current consumption in Stop and Standby modes.

Updated:

– Table: Temperature sensor calibration values,

– Table: Internal voltage reference calibration values,

– Table: Current characteristics,

– Table: General operating conditions,

– Table: Typical and maximum current consumption from the

VDDA supply,

– Table: Low-power mode wakeup timings,

– Table: I/O current injection susceptibility,

– Table: I/O static characteristics,

– Table: Output voltage characteristics,

– Table: NRST pin characteristics,

– Table: I2C analog filter characteristics,

– Figure: Power supply scheme,

– Figure: TC and TTa I/O input characteristics,

– Figure: Five volt tolerant (FT and FTf) I/O input

characteristics,

– Figure: I/O AC characteristics definition,

– Figure: ADC accuracy characteristics,

– Figure: Typical connection diagram using the ADC,

– Figure: LQFP64 – 10 x 10 mm 64 pin low-profile quad flat

package outline,

– Figure: LQFP64 recommended footprint,

– Figure: LQFP48 – 7 x 7 mm, 48 pin low-profile quad flat

package outline,

– Figure: LQFP48 recommended footprint,

– Figure: LQFP32 – 7 x 7 mm 32-pin low-profile quad flat

package outline,

– Figure: LQFP32 recommended footprint,

– Figure: UFQFPN48 – 7 x 7 mm, 0.5 mm pitch, package

outline.

118/122

DocID022265 Rev 7

Share Link: