STM8S207R8 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM8S207R8

Performance line, 24 MHz STM8S 8-bit MCU, up to 128 KB Flash, integrated EEPROM, 10-bit ADC, timers, 2 UARTs, SPI, I²C, CAN

STMicroelectronics 

STM8S207xx, STM8S208xx

Electrical characteristics

10.2

Absolute maximum ratings

Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage

to the device. This is a stress rating only and functional operation of the device under these

conditions is not implied. Exposure to maximum rating conditions for extended periods may

affect device reliability.

Table 15. Voltage characteristics

Symbol

Ratings

Min

Max

Unit

VDDx - VSS Supply voltage (including VDDA and VDDIO)(1)

-0.3

6.5

Input voltage on true open drain pins (PE1, PE2)(2) VSS - 0.3

6.5

V

VIN

Input voltage on any other pin(2)

VSS - 0.3 VDD + 0.3

|VDDx - VDD| Variations between different power pins

|VSSx - VSS| Variations between all the different ground pins

50

mV

50

VESD Electrostatic discharge voltage

see Absolute maximum

ratings (electrical

sensitivity) on page 86

1. All power (VDD, VDDIO, VDDA) and ground (VSS, VSSIO, VSSA) pins must always be connected to the

external power supply

2. IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum

cannot be respected, the injection current must be limited externally to the IINJ(PIN) value. A positive

injection is induced by VIN>VDD while a negative injection is induced by VIN<VSS. For true open-drain pads,

there is no positive injection current, and the corresponding VIN maximum must always be respected

Doc ID 14733 Rev 12

53/103

Share Link: