STM32L151CCH7DTR View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32L151CCH7DTR

Ultra-low-power 32-bit MCU ARM®-based Cortex®-M3, 256KB Flash, 32KB SRAM, 8KB EEPROM, LCD, USB, ADC, DAC

STMicroelectronics 

STM32L151xC STM32L152xC

Electrical characteristics

3. In Low-power sleep and run mode, the Flash memory must always be in power-down mode.

4. Data based on a differential IDD measurement between ADC in reset configuration and continuous ADC

conversion (HSI consumption not included).

5. Data based on a differential IDD measurement between DAC in reset configuration and continuous DAC

conversion of VDD/2. DAC is in buffered mode, output is left floating.

6. Including supply current of internal reference voltage.

6.3.5

Wakeup time from low-power mode

The wakeup times given in the following table are measured with the MSI RC oscillator. The

clock source used to wake up the device depends on the current operating mode:

• Sleep mode: the clock source is the clock that was set before entering Sleep mode

• Stop mode: the clock source is the MSI oscillator in the range configured before

entering Stop mode

• Standby mode: the clock source is the MSI oscillator running at 2.1 MHz

All timings are derived from tests performed under the conditions summarized in Table 14.

Symbol

Table 26. Low-power mode wakeup timings

Parameter

Conditions

Typ Max(1) Unit

tWUSLEEP Wakeup from Sleep mode

tWUSLEEP_LP

Wakeup from Low-power sleep

mode, fHCLK = 262 kHz

Wakeup from Stop mode,

regulator in Run mode

ULP bit = 1 and FWU bit = 1

tWUSTOP

Wakeup from Stop mode,

regulator in low-power mode

ULP bit = 1 and FWU bit = 1

tWUSTDBY

Wakeup from Standby mode

ULP bit = 1 and FWU bit = 1

Wakeup from Standby mode

FWU bit = 0

fHCLK = 32 MHz

fHCLK = 262 kHz

Flash enabled

fHCLK = 262 kHz

Flash switched OFF

0.4

-

46

-

46

-

fHCLK = fMSI = 4.2 MHz

8.2

-

fHCLK = fMSI = 4.2 MHz

Voltage range 1 and 2

7.7

8.9

fHCLK = fMSI = 4.2 MHz

Voltage range 3

8.2 13.1 µs

fHCLK = fMSI = 2.1 MHz

fHCLK = fMSI = 1.05 MHz

fHCLK = fMSI = 524 kHz

fHCLK = fMSI = 262 kHz

fHCLK = fMSI = 131 kHz

fHCLK = MSI = 65 kHz

10.2

16

31

57

112

221

13.4

20

37

66

123

236

fHCLK = MSI = 2.1 MHz 58 104

fHCLK = MSI = 2.1 MHz 2.6 3.25 ms

1. Guaranteed by characterization, unless otherwise specified

DocID022799 Rev 13

71/136

109

Share Link: