STM32F301C8T7(2014) View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

STM32F301C8T7
(Rev.:2014)

ARM® Cortex®-M4 32-bit MCU+FPU, up to 64 KB Flash, 16 KB SRAM, ADC, DAC, COMP, Op-Amp, 2.0 – 3.6 V

STMicroelectronics 

STM32F301x6 STM32F301x8

Electrical characteristics

Note:

For CL1 and CL2, it is recommended to use high-quality external ceramic capacitors in the

5 pF to 25 pF range (Typ.), designed for high-frequency applications, and selected to match

the requirements of the crystal or resonator (see Figure 16). CL1 and CL2 are usually the

same size. The crystal manufacturer typically specifies a load capacitance which is the

series combination of CL1 and CL2. PCB and MCU pin capacitance must be included (10 pF

can be used as a rough estimate of the combined pin and board capacitance) when sizing

CL1 and CL2.

For information on selecting the crystal, refer to the application note AN2867 “Oscillator

design guide for ST microcontrollers” available from the ST website www.st.com.

Figure 16. Typical application with an 8 MHz crystal

5HVRQDWRUZLWKLQWHJUDWHG

FDSDFLWRUV

&/

26&B,1

I+6(

0+]

UHVRQDWRU

%LDV

FRQWUROOHG

5)

JDLQ

5(;7 

26&B287

&/

1. REXT value depends on the crystal characteristics.

069

DocID025146 Rev 3

75/132

112

Share Link: