TDA75610S-QLX View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

TDA75610S-QLX

4 x 45 W power amplifier with full I2C diagnostics, high efficiency and low voltage operation

STMicroelectronics 

Diagnostics functional description

4

Diagnostics functional description

TDA75610SLV

4.1

Turn-on diagnostic

It is recommended to activate this function at the turn-on (standby out) through an I2C bus

request. Detectable output faults are:

 SHORT TO GND

 SHORT TO VS

 SHORT ACROSS THE SPEAKER

 OPEN SPEAKER

To verify if any of the above misconnections are in place, a subsonic (inaudible) current

pulse (Figure 23) is internally generated, sent through the speaker(s) and sunk back.The

Turn On diagnostic status is internally stored until a successive diagnostic pulse is

requested (after a I2C reading).

If the "standby out" and "diag. enable" commands are both given through a single

programming step, the pulse takes place first (during the pulse the power stage stays 'off',

showing high impedance at the outputs).

Afterwards, when the amplifier is biased, the PERMANENT diagnostic takes place. The

previous turn-on state is kept until a short appears at the outputs.

Figure 23. Turn-on diagnostic: working principle

9Va9

,VRXUFH

,P$

,VRXUFH

,VLQN

,VLQN

aPV

0HDVXUHWLPH

WPV

'!0'03

Figure 24 and 25 show SVR and OUTPUT waveforms at the turn-on (standby out) with and

without turn-on diagnostic.

Figure 24. SVR and output behavior (Case 1: without turn-on diagnostic)

6SVR

/UT

0ERMANENTDIAGNOSTIC

ACQUISITIONTIMEMS4YP

18/42

"IASPOWER AMPT URNON

)#"$!4!

$IAGNOSTIC %NABLE

0ERMANENT

&! 5,4

EVENT

2EAD$ATA

0ERMANENT$IAGNOSTICSDATAOUPUT

PERMITTEDTIME

DocID025599 Rev 6

T

'!0'03

Share Link: