ST72E632K2B0 View Datasheet(PDF) - STMicroelectronics

Part Name

Description

Manufacturer

ST72E632K2B0

LOW SPEED USB 8-BIT MCU FAMILY with up to 16K MEMORY, up to 512 BYTES RAM, 8-BIT ADC, WDG, TIMER, SCI & I2C

STMicroelectronics 

ST7263

8-BIT A/D CONVERTER (ADC) (Cont’d)

5.8.3 Functional Description

The high level reference voltage VDDA must be

connected externally to the VDD pin. The low level

reference voltage VSSA must be connected exter-

nally to the VSS pin. In some devices (refer to de-

vice pin out description) high and low level refer-

ence voltages are internally connected to the VDD

and VSS pins.

Conversion accuracy may therefore be degraded

by voltage drops and noise in the event of heavily

loaded or badly decoupled power supply lines.

Figure 43. Recommended Ext. Connections

VDD

VAIN

RAIN

0.1µF

VDDA

VSSA

ST7

Px.x/AINx

Characteristics:

The conversion is monotonic, meaning the result

never decreases if the analog input does not and

never increases if the analog input does not.

If input voltage is greater than or equal to VDD

(voltage reference high) then results = FFh (full

scale) without overflow indication.

If input voltage ≤ VSS (voltage reference low) then

the results = 00h.

The conversion time is 64 CPU clock cycles in-

cluding a sampling time of 31.5 CPU clock cycles.

RAIN is the maximum recommended impedance

for an analog input signal. If the impedance is too

high, this will result in a loss of accuracy due to

leakage and sampling not being completed in the

alloted time.

The A/D converter is linear and the digital result of

the conversion is given by the formula:

255 x Input Voltage

Digital result =

Reference Voltage

Where Reference Voltage is VDD - VSS.

The accuracy of the conversion is described in the

Electrical Characteristics Section.

Procedure:

Refer to the CSR and DR register description sec-

tion for the bit definitions.

Each analog input pin must be configured as input,

no pull-up, no interrupt. Refer to the “I/O Ports”

chapter. Using these pins as analog inputs does

not affect the ability of the port to be read as a logic

input.

In the CSR register:

– Select the CH2 to CH0 bits to assign the ana-

log channel to convert. Refer to Table 21

Channel Selection.

– Set the ADON bit. Then the A/D converter is

enabled after a stabilization time (typically 30

µs). It then performs a continuous conversion

of the selected channel.

When a conversion is complete

– The COCO bit is set by hardware.

– No interrupt is generated.

– The result is in the DR register.

A write to the CSR register aborts the current con-

version, resets the COCO bit and starts a new

conversion.

5.8.4 Low Power Modes

Note: The A/D converter may be disabled by re-

setting the ADON bit. This feature allows reduced

power consumption when no conversion is need-

ed.

Mode

WAIT

HALT

Description

No effect on A/D Converter

A/D Converter disabled.

After wakeup from Halt mode, the A/D

Converter requires a stabilisation time

before accurate conversions can be

performed.

5.8.5 Interrupts

None.

85/109

Share Link: